Denon PMA-2020AE Owner's Manual download pdf (Page 16)

Rear panel

uio

yq ew r t t

q Input connectors (INPUTS) ··················································· (6, 7)

w Power ampliﬁer direct connectors

(POWER AMP DIRECT) ······························································ (6)

Connectors for directly inputting signals to the power ampliﬁer.

The volume should be adjusted on the connected device.

e Input/output connectors (Recordings)

(RECORDER) ··············································································· (7)

r PRE OUT connectors ································································· (6)

Use this to add such equipment as a power ampliﬁer or subwoofer.

t Speaker system terminals

(SPEAKER SYSTEMS) ··························································· (5, 6)

y AC inlet (AC IN) ·········································································· (7)

u REMOTE CONTROL jacks

Extension jack for future use.

i SIGNAL GND (ground) terminal ·············································· (6)

o CARTRIDGE selection switch

This switch is set according to the type of player cartridge to be

used. Set this switch to MM (j) or MC (h) according to the type

of cartridge used on your turntable.

NOTE

•This terminal is not a safety ground.

•The SIGNAL GND terminal of this unit is not a safety ground

connection. Connect it to reduce noise when noise is excessive.

Note that depending on the record player, connecting the ground

line may have the reverse effect of increasing noise. In this case, it

is not necessary to connect the ground line.

•The PHONO input terminals are equipped with a short pin-plug.

Remove this plug to connect a record player.

Store the removed short pin-plug in a safe place so as not to lose it.

•Signals are outputted from the PRE OUT connectors even when

using headphones.

Preparations

Operations

InformationInformation

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 22

No comments

Denon PMA-2020AE Owner's Manual Page 16