Denon AVR-4800 Operations Instructions download pdf (Page 21)

Enter the setting.

a) If no surround speakers are used (if “None” is set for both A and B):

The System Setup Menu reappears.

b) If both surround speakers A and B are used (if either “Large” or “Small” is set for both A and B):

The surround speaker setting screen appears.

c) When “Front” is set to “Large” and “Subwoofer” is set to “Yes”, the set switches to the subwoofer mode.

d) If “None” is set for surround speakers A:

“None” is automatically set for surround speakers B and surround back speaker.

ENTER

NOTE:

• Select “Large” or “Small” not according to the actual size of the speaker but according to the speaker’s capacity for playing low frequency

(approximately 80 Hz and below) signals. If you do not know, try comparing the sound at both settings (setting the volume to a level low

enough so as not to damage the speakers) to determine the proper setting.

• Parameters

Large................Select this when using speakers that can fully reproduce low sounds of below 80 Hz.

Small................Select this when using speakers that cannot reproduce low sounds of below 80 Hz with sufficient volume.

When this setting is selected, low frequencies of below 80 Hz are assigned to the subwoofer.

None…….........Select this when no speakers are installed.

Yes/No…..........Select “Yes” when a subwoofer is installed, “No” when a subwoofer is not installed.

2spkrs/1spkr.....Select the number of speakers to be used for the surround back channel.

If the subwoofer has sufficient low frequency playback capacity, good sound can be achieved even when “Small” is set for the front, center

and surround speakers.

To take full advantage of the performance of the Home THX certified speaker systems, set the front, center and surround speaker size

parameters to “Small” and the subwoofer to “Yes”.

For the majority of speaker system configurations, using the SMALL setting for all five main speakers and Subwooofer On with a connected

subwoofer will yield the best results.

When “Front” is set to “Small”, “Subwoofer” is automatically set to “Yes”, and when “Subwoofer” is set to “No”, “Front” is automatically

set to “Large”.

Selecting the surround speakers for the different surround modes

• At this screen preset the surround speakers to be used in the different surround modes.

When either “Large” or “Small” has been set for both speakers A and B

on the System Setup Menu (when using both A and B surround speakers),

the surround speaker setting screen appears.

Select the surround speakers to be used in the different surround modes.

• To select the surround mode

• To select the surround speaker

A: When using surround speakers A

B: When using surround speakers B

A+B: When using both surround speakers A and B

Enter the setting.

When “Front” is set to “Large” and “Subwoofer” is set to “Yes”, the set switches to the subwoofer mode.

ENTER

Speaker type setting when using both surround speakers A and B

If “Small” is set for either surround speakers A or B, the output is the same as when “Small” is set for both A and B.

For the “WIDE SCREEN” and “5/7CH STEREO” DSP simulation modes, the surround speakers can be set separately.

Setting the Subwoofer mode

Select the bass signal playback mode.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 68 69

Comments to this Manuals

No comments

Denon AVR-4800 Operations Instructions Page 21

Comments to this Manuals

Related products and manuals for AV receivers Denon AVR-4800