Denon DBP 4010UDCI User Manual download pdf (Page 10)

ENGLISH



TroubleshootingInformationHDMI Control FunctionPlaybackSetupConnections Specications

Inserting the Batteries

About the Remote Control Unit

e Put the rear cover back on.

q Remove the remote control

unit’s rear cover.

w Set three R6/AA batteries in

the battery compartment in the

indicated direction.

NOTE

Use R6/AA batteries in this remote control.

Replace the batteries with new ones if the set does not operate

even when the remote control unit is operated close to the unit.

(The supplied batteries are only for verifying operation.)

When inserting the batteries, be sure to do so in the proper direction,

following the “q” and “w” marks in the battery compartment.

To prevent damage or leakage of battery uid:

Do not use a new battery together with an old one.

Do not use two different types of batteries.

Do not attempt to charge dry batteries.

Do not short-circuit, disassemble, heat or dispose of batteries in

ames.

If the battery uid should leak, carefully wipe the uid off the inside

of the battery compartment and insert new batteries.

Remove the batteries from the remote control unit if it will not be in

use for long periods.

Used batteries should be disposed of in accordance with the local

regulations regarding battery disposal.

•

Operating Range of the Remote Control

Unit

Point the remote control unit at the remote sensor when operating

it.

30°

Approx.23feet/7m

NOTE

The set may function improperly or the remote control unit may not

operate if the remote control sensor is exposed to direct sunlight,

strong articial light from an inverter type uorescent lamp or infrared

light.

Remote Control Settings (Remote

Control Side)

Switches when the DBP-4010UDCI’s remote control operates

another DENON BD players in the vicinity.

Set the remote control code simultaneously on the main unit, too.

For how to set codes, see GUI menu: “Other Setup” – “Remote

Control Setting” – “Remote ID” (vpage 31).

GRemote control code settingH

: Set the remote control code to “1”.

: Set the remote control code to “2”.

If the signal code of the remote control does not match the signal

code of the unit, the remote control code set on the unit is shown

on the display.

GExampleH

If the code setting on the unit is “DENON 1”, and the setting on the

remote control is “2”, “PLAYER 1” is shown on the display.

NOTE

Match the signal code of the remote control with the signal code of

the unit. If the remote control code is different, you cannot operate

the DBP-4010UDCI with the remote control.

Even if you change the remote control code, set GUI menu “Other

Setup” – “Remote Control setting” – “Receive Legacy Remocon”

(vpage 31) to “Off” when operating the DBP-4010UDCI with a

remote control other than DENON’s.

•

Getting Started

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 68 69

Comments to this Manuals

No comments

Denon DBP 4010UDCI User Manual Page 10

Comments to this Manuals

Related products and manuals for Blu-Ray players Denon DBP 4010UDCI