Denon RCD-M38 Owner's Manual download pdf (Page 11)

ENGLISH

This section explains how to connect speakers, recording

equipment, and antennas.

For other connections, see the sections below.

n Control dock for iPod (vpage16)

n USB memory device (vpage16)

n iPod (vpage16)

NOTE

• Do not plug in the power cord until all connections have been

completed.

• When making connections, also refer to the owner’s manual of the

other components.

• Be sure to connect the left and right channels properly (left with left,

right with right).

• Do not bundle power supply cords together with connection cables.

Doing so can result in humming or noise.

Basic connections

Speaker connections

Audio cable (sold separately)

Pin-plug cable

(Black)

Speaker cable

(R) (L)

wq wq

Speaker SC-M37 (Supplied)

Subwoofer

with built-in

ampliﬁ er

Connecting the speaker cables

Carefully check the left (L) and right (R) channels and + (red) and –

(black) polarities on the speakers being connected to the unit, and be

sure to connect the channels and polarities correctly.

Peel off about 10 mm of sheathing

from the tip of the speaker cable, then

either twist the core wire tightly or

apply solder to it.

Turn the speaker terminal

counterclockwise to loosen it.

Insert the speaker cable’s core wire to

all the way into the speaker terminal.

Turn the speaker terminal clockwise

to tighten it.

NOTE

• Use speakers with an impedance of 6 to 16 Ω. The protection circuit

may be activated if speakers with an impedance other than speciﬁ ed

are used.

• Connect the speaker cables so they do not stick out of the speaker

terminals. The protection circuit may be activated if the wires

touch the rear panel or if the + and – sides touch each other (v

“Protection circuit”).

• Never touch the speaker terminals while the power supply is

connected. Doing so could result in electric shock.

Protection circuit

The protection circuit is be activated in the following situations:

• If the speaker cable wire touches the rear panel or screws or if the

speaker cable wire touches the speaker cable’s + and – sides are

touching

• If the surrounding temperature is extremely high

• If the inside of the ampliﬁ er gets hot to extended use at a high

output

If this happens, unplug the power cord, then check the connections

of the speaker cables and input cables. If the unit becomes very hot,

wait for it to cool off and improve the ventilation around it. After doing

this, plug the power cord back in.

If the protection circuit is activated even though there are no problems

with the ventilation around the unit or in connections, the unit may

be damaged. Turn off the power and then contact a DENON service

center.

1.RCDM38E3_ENG_004_1st.indd 81.RCDM38E3_ENG_004_1st.indd 8 2010/05/17 14:17:052010/05/17 14:17:05

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 36 37

Comments to this Manuals

No comments

Denon RCD-M38 Owner's Manual Page 11

Comments to this Manuals

Related products and manuals for Car media receivers Denon RCD-M38