Denon RCD-N7 User Manual download pdf (Page 9)

ConnectionsConnections

Basic Operations Advanced Operations TroubleshootingExplanation termsInformation Speciﬁ cations Index

ENGLISH

Getting Started

This section explains how to connect speakers, recording

equipment, antennas and network.

For other connections, see the sections below.

NOTE

• Do not plug in the power cord until all connections have been

completed.

• When making connections, also refer to the owner’s manual of the

other components.

• Be sure to connect the left and right channels properly (left with left,

right with right).

• Do not bundle power supply cords together with connection cables.

Doing so can result in humming or noise.

Connections

Speaker connections

Audio cable (sold separately)

Pin-plug cable

(Black)

Speaker cable

COAX.

75ǡ

LOOP

ANT.

SPEAKERS

ETHERNET

NETWORK

ANTENNA

TUNER

AUX OUT AUX IN 1 AUX IN 2

AUX IN 3

(OPTICAL)

WLAN ANTENNA

SPEAKERS INPEDANCE 4-16 ǡ

RCD-N7W

PREOUT

SUBWOOFER

wqwq

Subwoofer with

built-in amp

Input terminals

Speaker SC-N7

NOTE

Be sure to lower the audio volume before making speaker settings.

Connecting the speaker cables

Carefully check the left (L) and right (R) channels and + (red) and –

(black) polarities on the speakers being connected to the unit, and be

sure to connect the channels and polarities correctly.

Peel off about 10 mm of sheathing

from the tip of the speaker cable, then

either twist the core wire tightly or

apply solder to it.

Turn the speaker terminal

counterclockwise to loosen it.

Insert the speaker cable’s core wire to

all the way into the speaker terminal.

Turn the speaker terminal clockwise

to tighten it.

NOTE

• Use speakers with an impedance of 4 to 16 Ω. The protection circuit

may be activated if speakers with an impedance other than speciﬁ ed

are used.

• Connect the speaker cables so they do not stick out of the speaker

terminals. The protection circuit may be activated if the wires

touch the rear panel or if the + and – sides touch each other

(vpage6 “Protection circuit”).

• Never touch the speaker terminals while the power supply is

connected. Doing so could result in electric shock.

• When you connect optional speakers (SC-N7) to this unit, you can

perform the ﬁ lter setting for optimal sound quality output (vpage35

“Using an optimizing ﬁ lter”).

1.RCDN7E3_ENG_008.indd 51.RCDN7E3_ENG_008.indd 5 2010/09/03 11:11:372010/09/03 11:11:37

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 57 58

Comments to this Manuals

No comments

Denon RCD-N7 User Manual Page 9

Comments to this Manuals