Denon DN-730R User Manual Page 6

  • Download
  • Add to my manuals
  • Print
  • Page
    / 25
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 5
IDN-730RI
j DISASSEMBLY INSTRUCTIONS j
1. How to Remove the Front Panel
(1i Remove the four screws, (4 X 12. CBTS-P) in the side of the
top cover. Move the top cover to the rear and rise it to
remove it.
(2) Press the eject knob, open the cassette box and remove the
cassette window as shown in the figure. .
Note: Handle the cassette window with care because it
can be scratched easily.
(3' Remove the three screws (3x10 CBTS-P) on top of the
front panel, the two hooks on the top, the three hooks on
the bottom and pull the unit forward to detach it.
Meter circuit
board
Audio
circuit
board
(3) Disconnect all lead connectors.
C Mechanism ( W151 (7P) — CN151 '
I Head wire — CN301
1
Head wire — CN302
I W131 (3P) - CN131
1
23PFFC-CB121 .
Remove Volume Knob and Volume Knob (C).
Remove the four retaining screws (2 6 x 6 CBTS(Si)-Z) (3
X 10 CBTS(P)-B) holding the Mecha Bracket.
Remove the Hooks at the left and right of the f 'ont face of
the Front Esc. Ass'y, and the two hooks on the bottom.
Front Ass'y can be removed towards the front.
(4)
(5)
(6)
Hooks at left and right of Front Esc. Ass'y
3. How to Remove the Mec hanisms
Remove the four Mechanism retaining screws 3x10 CBTS(P)-B
and lake out C Mechanism.
T
2 hooks on the top of the front panet
m,...i. i. .... a
_ _____________0_
T
4. How to Remove the Meter Circuit Board
(1) Remove the top cover and the front panel. (Refer to section
1.)
(2) Remove the front esc. ass'y, (Refer to section 2.)
(3) If you remove the five binding screws (3x8 CBTS -P tight)
of the meter circuit board, and loosening the five hooks, the
meter circuit board can be taken off.
Note; When replacing the tact switch, check to make sure
that It is not floating above the circuit board. If it is
floating, the switch will oe in the on condition when
the set is assembled
3 hooks on the bottom of the front panel
o
X
2. How to Remove the Front Escutcheon Ass'y
(1) Remove the top cover and front panel. (Refer to Step 1 )
(2) Remove the three retaining screws 3x10 CBTS-(P)-B
holding the Front Escutcheon at the front.
Page view 5
1 2 3 4 5 6 7 8 9 10 11 ... 24 25

Comments to this Manuals

No comments