Denon Cocoon Home Owner's Manual Page 29

  • Download
  • Add to my manuals
  • Print
  • Page
    / 42
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 28
26
n Notes concerning use of “Firmware Update”
•Do not turn off the power until updating or upgrading is completed.
•Even with a broadband connection to the Internet, approximately
20 minutes is required for the updating procedure to be
completed.
•Once updating starts, normal operations on this unit cannot be
performed until updating is completed. Furthermore, updating
the firmware may reset the backup data for the parameters, etc.
set for this unit.
•If the update fails, remove and re-insert the power cord. “Update
Retry” appears on the display and update restarts from the point
at which update failed. If the error continues despite this, check
the network environment.
See the DENON website for details about updates.
Setting the network (Network Info.)
Firmware Update
•In order to update the firmware, the environment and settings
required for connecting to broadband internet are needed
(vpage8)
•Perform the firmware update operation after at least 2 minutes has
elapsed since turning this unit’s power ON.
1
Press + and at the same time.
Turns on the menu settings mode and the menu appears on the
display (vpage22 “Menu map”).
2
Press + or to select “Firmware Update”, then press
13.
3
Press + or to select “Check for Update” or “Start”,
then press 13.
Check for Update
Check for firmware updates.
Use
+ or to select the item, and press 13.
•Up to Date: It is already the latest firmware.
•Available Yes: Updates to the latest firmware.
•Available No: Does not update to the latest firmware.
Start
Determines whether to update or not.
Use
+ or to select the item, and press 13.
•Yes: Performs update.
•No: Does not perform update.
•If updating fails, the set automatically retries, but if updating is still
not possible, one of the messages shown below is displayed. If
the display reads as shown below, check the settings and network
environment, then update again.
Display Description
Updating fail Updating failed.
Login failed Failure to log into server.
Server is busy Server is busy. Wait a while then try again.
Connection fail Failure in connecting to server.
Download fail Downloading of the firmware has failed.
Auto standby
With the Auto Standby ON, this unit will automatically enter the
standby mode after about 30 continuous minutes of stop mode with
no operation.
•The default setting for the Auto Standby mode is “On”.
1
Insert the power plug into the
power outlet and press X.
“Always Display Clock?” is displayed.
2
Press + or to select “Yes” or
“No”, then press 13.
Yes
(Auto Satandby Off)
The unit does not go into standby automatically.
No
(Auto Satandby On)
The unit goes into standby after 30 minutes.
NOTE
In the following situations, the Auto standby function does not operate.
•When iPod, iPhone or iPad is connected to the Dock connector on
this unit.
•When the input source is “AUX” and a devices connected to the
AUX IN jack.
•When the input source being played is “Internet Radio”or “Music
Server”.
Preparations
Operations
Informations
Operations
Page view 28
1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 41 42

Comments to this Manuals

No comments