Denon CEOL Piccolo Owner's Manual Page 18

  • Download
  • Add to my manuals
  • Print
  • Page
    / 65
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 17
15
Setting the network [Network]
Connecting wired LAN
Use this procedure to configure the wired LAN settings.
n Network connecting
(when “DHCP”settings are “On”)
When using this unit with the broadband router’s DHCP function
enabled, this unit automatically performs the IP address setting
and other settings.
1
Connect the ETHERNET cable
(vpage 7 “Connecting to a
home network (LAN)” – “Wired
LAN”).
2
Press POWER X to turn on
power to the main unit.
3
Press SETUP.
Turns on the Menu settings mode
and the Menu appears on the display
(vpage9 “Menu map”).
4
Use ui and ENTER to select
“Network” – “Settings” –
“DHCP (On)”, then press ENTER
or p.
“Select DHCP” menu appears.
5
Use ui to select “On”, then press ENTER or p.
“DHCP (On)” menu appears.
6
Use ui to select “Test Connection”, then press
ENTER or p.
“Wait for the network to connect...” is displayed, and the unit
starts connecting to the LAN.
•When the connection is made successfully, “Connected!” appears.
•If the connection cannot be established, “Connection Failed” is
displayed. Perform steps 1 – 6 again.
You may need to set the network connection manually, depending
on the provider you use. To set the connection manually, use the
setting procedure of “Network connecting (when “DHCP” settings
are “Off”)”.
n Network connecting
(when “DHCP” setting is “Off”)
This section explains the settings when connecting this unit to a
network that does not have a DHCP function.
To configure the settings manually, check the setting details with
your network administrator.
1
Perform steps 1 4 of the
“Network connecting (when
“DHCP” settings are “On”)”
procedure and select “Off” in
step 5.
“DHCP (Off)” menu appears.
2
Use ui to select “IP Address”,
then press ENTER or p.
“Enter IP Address” menu appears.
3
Use uip or 0 – 9 to input the
IP address and press ENTER.
4
Use uip or 0 – 9 to input the address for
“Subnet Mask”, “Gateway”, “Primary DNS”, and
“Secondary DNS”.
5
Use ui to select “Test Connection”, then press
ENTER or p.
“Wait for the network to connect...” is displayed, and the unit
starts connecting to the LAN.
•When the connection is made successfully, “Connected!” appears.
•If the connection cannot be established, “Connection Failed” is
displayed. Perform steps 1 – 4 again.
Preparations
Operations
Information
Preparations
Page view 17
1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 64 65

Comments to this Manuals

No comments