Denon AVR-2500 User Manual

jpM:;: I '' I :^: : v : T:AV SURROUND RECEIVERAVR-2500OPERATING INSTRUCTIONSThe photograph shows the AVR-2500 (black), (without side

3-2 Preset memoryThis remote control unit can be used to operate components of other manufacturers without using the manufacturer of th

'TV"fT] button [T] buttonfT| button1DENON-2 (VOP/TV)HITACH! A HITACHI B3 (PHONO)MiTSUSISHi AMITSUBISHI 8MITSUBISHI C4 (TUNER)PANASONIC~~5 (V

3-3 Remote Control Unit Learning FunctionUse the [earning function to operate audio components manufactured by companies other than Denon

4 OPERATIONS4-1 Preparations for Play Back1. Check that all connectiond are proper.2. Set to the minimum position.MASTER VOLUME3. Set to the center

4-3 Adjusting the BALANCE control and TONE control1. Adjust the front left/right BALANCE.Turn the control counterclockwise to reduce the volum

4~7 Multi-Source recording/playbackThe Multi-Source function allows you to record a source other than the source currently playing or

• Before using the surround functionMake the following adjustments before using the surround function.1, Set the Dolby Pro Logic mode.OOCSV PRO

• Using the surround function1. Select the surround mode according to the input source.SUPE«STADIUMMODE.Jii...^ ^5i„y72, if necessary, adjust t

^ LISTENING TO THE RADIO5-1 Auto preset memoryThis unit is equipped with a function for automatically searching for FM broadcast stations and

3. Press the SHIFT button and select the desired memory block (A to D).4. Press the PRESET UP or DOWN button to select the desired preset channel (1

TABLE OF CONTENTSmBRemote Control Unit3'1 System code buttons...3-2 Preset memory...

5-7 RDS search ^Use this function to automatically tune to FiVl stations that provide RDS service.1, Set the input function to "TUNER".AUDI

5-9 TP searchUse this function to find RDS stations broadcasting traffic program (TP stations).1. Set the input function to "TUNER".Set the

6 EASY OPERATiOIM FUNCTIONSThis unit is equipped with the functions described below to make operation simpler.6-1 On-screen displayEach time an ope

LAST FUNCTION MEMORYThis receiver is equipped with a last function memory which stores the input and output setting conditions as th

¡iol SPECIFICATIONSAudio Section {Power amplifier)Rated output:{All properties shown are only for the power amplifier stage.)Output terminals:for

SAFETY INSTRUCTIONS1. Read Instructions - All the safety and operating instructions should be read before the appliance Is operated,2.

* NOTE ON USE• INSTALLATION PRECAUTIONSUsing this receiver or other electronic equipment containingmicroprocessors simultaneously with a tuner or TV

2 CONNECTIONSDo not plug in the power cord until all connections have been completed.Be sure to connect the left and right channels

2-2 Speaker System Connections• This receiver can accommodate connectiorrs of a total of eight speakers including two set of (front) m

2-4 Connecting the video componentsTo connect the video signal, connect using a 75 0/ohms video signal cable cord. Using an improper cable

Ш NORTH AMERICA MODEL ONLY * AC OUTLETSSWITCHED lEOWtIAIMAX. AC OUTlfTS t20V-e0KiNOTE:Only use the AC outlets for audio equipnnent. Never use them for

3 REMOTE CONTROL UNITFollowing the procedure outlined below, insert the batteries before using the remote control unit.Range of operation of the remot