Denon AVR-890 User Manual download pdf (Page 57)



ENGLISH

Getting Started

Connections Playback Remote Control Information Troubleshooting

SpeciﬁcationsSettings

Playing 2-Channel Sound in ZONE2 (Multizone Function)

2-channel sound can be played in rooms other than the MAIN

ZONE where multichannel sound is played.

There are two methods to do this, as described below. Choose

one of the methods.

q ZONE2 playback by speaker output

wZONE2 playback by audio output (PRE OUT) (using an

external amplifier))

q ZONE2 Playback by Speaker

Output

Preparations

Connecting and setting the speakers

Connecting the speakersn

w q w q

(L) (R)

Necessary settings

Set the AMP ASSIGN mode to “ZONE2”.

“Amp Assign” (vpage 27)

Perform the settings at “ZONE2 Setup”.

“Making the ZONE2 settings” (vpage 31)

•

w ZONE2 Playback by Audio

Output

Connection (ZONE2)

The audio signals connected to the AVR-890’s ZONE2 output terminals

(ZONE2 OUT) are output to the ZONE2’s ampliﬁer and played with that

ampliﬁer.

"69

Adjust the volume on the connected ampliﬁer.

Also be sure to read the operating instructions of the connected

devices.

•

Set the remote control unit’s

“device selector switches” as

shown on right.

 Turn on the AVR-890’s power.

(vpage 19 “Turning the Power On”)

 Press to turn on the ZONE2 power.

When the power turns on, the “ ” indicator lights on the

display.

b The power can be turned on by pressing the one of

while in the standby mode.

 Use the input source selector to choose the input

source.

The selected input source is shown on the display.

NOTE

When “SOURCE” is selected for the input source, the sound being

played in the MAIN ZONE is played. No sound is output if a digital

audio input source is being played in the MAIN ZONE.

Adjusting the volume (for “q ZONE2 playback by

speaker output”)

Use

to adjust the volume.

GVariable rangeH

– – –

–80dB(1)

–40dB(41)

+18dB(99)

b The volume can be adjusted up to the level set at “Vol. Limit”

(vpage 31).

b The volume display is the display set at “Volume Display”

(vpage 31).

AVR-890

The operation is the same for “q ZONE2 playback by speaker

output” and “w ZONE2 playback by audio output”.

Playback

MAIN ZONE

ZONE2

Rear

For “w ZONE2 playback by audio output”, adjust the volume on the

connected ampliﬁer.

NOTE

• We recommend using high quality pin-plug cables for audio

connections in order to prevent noise.

• It is not possible to play the digital audio signals input from the

HDMI, COAXIAL or OPTICAL terminals in ZONE2. Play using analog

connections (in stereo).

With the Amp Assign function, Zone 2 audio signals are output from

the AVR-890's SURR BACK/AMP ASSIGN terminals.

Multi-Zone

1 2 ... 52 53 54 55 56 57 58 59 60 61 62 ... 75 76

Comments to this Manuals

No comments

Denon AVR-890 User Manual Page 57

Comments to this Manuals

Related products and manuals for Home Theater Systems Denon AVR-890