24
Wi-Fi Protected Setup (WPS)
Settings (PIN code method)
Sets the wireless connection using WPS (PIN code method).
This setting item is not displayed when using a wired connection.
Before turning this unit on, make sure that an LAN cable is not
connected to this unit.
When a LAN cable is connected, set the power to standby and
disconnect the LAN cable.
1
Press and hold for more than
3 seconds.
Settings
2
Press + or – to select “WPS(PIN)”,
then press 13.
WPS(PIN)
•“Searching” is displayed, and the access point you have set is
displayed.
3
Press + or – to select the access point whose PIN code
you want to display, and press 13.
The PIN code number is displayed.
4
Set this PIN code to the register.
•For how to register the PIN code, see the owner’s manual of your
router with access point.
•When connection is established with access point, “Connected!”
is displayed.
n Exiting the menu to return to the normal mode
Press until the input source is displayed.
•The unit exits the setting mode and the normal display returns.
To return to the previous item, use + or – to select “Back” and then
press 13, or press .
Network Control
Set the network function on or off during standby.
•The default setting is “Off”.
1
Press and hold for more than
3 seconds.
Settings
2
Press + or – to select “Network
Control”, then press 13.
Network Control(Off)
Network Always On
Network is on during standby. Main unit is
operable with a network compatible controller.
Network Off in
Standby
Suspends the network function during standby.
NOTE
When “Network Control” is set to “Network Always On”, it consumes
more standby power.
n Exiting the menu to return to the normal mode
Press until the input source is displayed.
•The unit exits the setting mode and the normal display returns.
To return to the previous item, use + or – to select “Back” and then
press 13, or press .
Auto-Standby
With the Auto Standby set to ON, this unit will automatically enter the
standby mode after about 30 continuous minutes of stop mode with
no operation.
•The default setting is “On”.
1
Press and hold for more than
3 seconds.
Settings
2
Press + or – to select “Auto-
Standby”, then press 13.
Auto-Standby(On)
Auto-Satandby Off
The unit does not go into standby automatically.
Auto-Satandby On
The unit goes into standby after 30 minutes.
NOTE
In the following situations, the Auto standby function does not operate.
•When the input source is “AUX” and a devices connected to the
AUX IN jack.
•When the input source being played is “Internet Radio”or “Music
Server”.
n Exiting the menu to return to the normal mode
Press until the input source is displayed.
•The unit exits the setting mode and the normal display returns.
To return to the previous item, use + or – to select “Back” and then
press 13, or press .
Comments to this Manuals