Denon DN-X800 User Manual download pdf (Page 9)

ENGLISH

REPLACING THE CROSSFADER

The Crossfader may be removed without any disassembly of the DN-X800 itself, and may be performed while the unit is operating

with no interruption of the audio signal.

1. Remove the two (2) outer screws attaching the crossfader assembly to the front panel.

2. Pull the Crossfader Assembly forward and unplug the ribbon from the connector on the panel board.

3. Install the replacement assembly by reversing the above instructions.

SPECIFICATIONS

■ GENERAL

Dimensions: 482 (W) x 105 (H) x 177 (D) mm (without feet)

Installation: 19-inch rack mountable 4U

Mass: 5.5 kg

Power supply: 230 V AC ±10%, 50 Hz (Europe model)

220 V AC ±10%, 50 Hz (China model)

Power consumption: 26 W

Environmental conditions: Operational temperature: 5 to 35°C (41 to 95°F)

Operational humidity: 25 to 85% (no condensation)

Storage temperature: -20 to 60°C (4 to 140°F)

■ AUDIO SECTION

Input Sensitivity & Impedance:

Main Mic -54 dBV (2.0 mV) 10 kΩ/kohms

Aux Mic -60 dBV (1.0 mV) 10 kΩ/kohms

Effect (Return) -14 dBV (200 mV) 50 kΩ/kohms

3-Phono -50 dBV (3.0 mV) 50 kΩ/kohms

8-Line -14 dBV (200 mV) 50 kΩ/kohms

Output level & Impedance:

Main (Balanced) 4 dBm (1.23 V) 600 Ω/ohms load

Main (Unbalanced) 0 dBV (1.0V) 1 kΩ/kohms

Zone (Balanced) 4 dBm (1.23 V) 600 Ω/ohms load

Booth (RCA) 6 dBV (2.0 V) 1 kΩ/kohms

Tape (RCA) -10 dBV (316 mV) 1 kΩ/kohms

Effect (Send) -14 dBV (200 mV) 1 kΩ/kohms

Subwoofer -2 dBV (800 mV) 1 kΩ/kohms

Headphone -4 dBV (630 mV) 150 Ω/ohms

Frequency Response:

Line 20 to 20 kHz ±2 dB

Phono 20 to 20 kHz RIAA ±2 dB

Mic 20 to 20 kHz ±2 dB

Signal to Noise ratio:

Line 80 dB 0 dBm, 1 kHz, EQ flat

Phono 75 dB 0 dBm, 1 kHz, EQ flat

Main Mic 65 dB 0 dBm, 1 kHz, EQ flat

Total harmonic distortion rate:

Line Below 0.05%

Phono Below 0.05%

Cross talk: Over 70 dB

Channel equalizer:

Hi +10 dB, -26 dB (13 kHz)

Mid +10 dB, -26 dB (1 kHz)

Low +10 dB, -26 dB (100 Hz)

Microphone equalizer:

Hi +12 dB, -12 dB (10 kHz)

Mid +12 dB, -12 dB (1 kHz)

Low +12 dB, -12 dB (100 Hz)

Digital input:

Input sensitivity -20 dBV (100 mV)

Signal format SPDIF

Output level 0.5 Vp-p 75 Ω/ohms

Digital output:

Signal format IEC958 Type

Output level 0.5 Vp-p 75 Ω/ohms

Output signal level -6 dB

✽ Specifications and design are subject to change without notice for purpose of improvement.

1 2 3 4 5 6 7 8 9 10 11 12 13 14 15 16

Comments to this Manuals

No comments

Denon DN-X800 User Manual Page 9

Comments to this Manuals

Related products and manuals for Musical Instruments Denon DN-X800