Denon AVR 689 - AV Receiver Owner's Manual Page 46

  • Download
  • Add to my manuals
  • Print
  • Page
    / 71
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 45
Specifi cations

iPod
®
Playback
The music on an iPod can be played by using the control dock for
iPod (ASD-1R, ASD-11R, ASD-3N or ASD-3W, sold separately).
The operation can also be performed using the buttons on the
remote control unit.
iPod is a trademark of Apple Inc., registered in the U.S.
and other countries.
b The iPod may only be used to copy or play contents that are not
copyrighted or contents for which copying or playback is legally
permitted for your private use as an individual. Be sure to comply
with applicable copyright legislation.
4
Press [MODE] and hold it down for a 2 seconds or
more to select the display mode.
To switch between modes, press and hold down the button.
When remote mode is active, “Remote” is displayed.
[Selectable mode]
Browse mode Remote mode
Display location Main unit display
iPod display
Playable
files
Audio file
S S
Video file
S
z
1
S
z
2
Active
buttons
Remote
control unit
(AVR-689)
S S
iPod
A S
z
1
:
When using an ASD-3N or ASD-3W control dock for iPod.
z
2
: Video may not be output, depending on the combination of ASD-1R
or ASD-11R and iPod.
With the default settings, the iPod can be used connected to the VCR
(iPod) connector.
Use the RESTORER mode to expand the low and high frequency
components of compressed audio les and achieve a richer sound.
The default setting is “Mode3” (vpage 37).
Press <ON/STANDBY> or [OFF] and set the AVR-689’s power to
the standby mode before disconnecting the iPod. Also switch the
input source to one to which “iPod Assignis not assigned before
disconnecting the iPod.
When using an ASD-3N or ASD-3W control dock for iPod, refer to the
respective manual to operate.
<SOURCE SELECT>
<STATUS>
<ON/STANDBY>
[iPod]
[OFF]
[SOURCE
CONTROL 1]
[SOURCE
CONTROL 2]
[ENTER]
[1]
[2]
[8], [9]
[6], [7]
[uip]
[uip]
[ENTER]
[MODE]
[iPod]
[TUNING + –]
[Front] [Rear]
Button located on both the main unit and the remote control
unit
BUTTON
Button only on the main unit
<BUTTON>
Button only on the remote control unit
[BUTTON]
Symbols used to indicate buttons in this manual
Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting
ENGLISH
1
Make the necessary preparations.
q Set the iPod in the DENON control dock for iPod.
(vSee the control dock for iPod’s operating instructions.)
w Assign the control dock for iPod’s input.
The input for the control dock for iPod is assigned to VCR by
default.
“System Setup” “Input Setup” “iPod Assign”
(vpage 26)
2
Either turn <SOURCE SELECT> or press [iPod] to
select the input source assigned in step 1-w above.
3
Set [SOURCE CONTROL 1] to “AUDIO” and [SOURCE
CONTROL 2] to “iPod/NETWORK”.
(v page 47 “Remote Control Unit Operations”)
Preparations
Page view 45
1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 70 71

Comments to this Manuals

No comments