Denon AVR-5700 User Manual download pdf (Page 25)

CAUTION!

• The master volume is set to “–30 dB” when test tones are output.

• The test tones are for confirming the low frequency playback limits and are played at an extremely high level. When using a low output

subwoofer, be very careful about irregular operations exceeding clipping by for example turning down the subwoofer’s attenuator before

starting then slowly turning the attenuator up to the listening level.

• Also, when the subwoofer is set to “NO” in the speaker configuration, the test tones are output from the front speakers. When using front

speakers with low input resistance, check that the sound is not clipped at sections where the signal is strong on the CD music source

before starting the peak limit setting. The peak limit setting should not be performed if the music source cannot be played with the master

volume set at “–15”. Set the front speakers to “small” and the subwoofer to “YES” in the speaker configuration. When this is done, the

low frequencies are cut, so the effect is insufficient. We strongly recommend adding a subwoofer.

• If the test tone is clipped when it is set to “–18 dB”, set the peak limit to “–18 dB”. In this case, the input resistance of the subwoofer or

front speakers is insufficient so clipping may occur when playing music. We recommend switching to a subwoofer with a higher input

resistance.

Setting the digital inputs

• This setting assigns the digital input jacks of the AVR-5700 for the different input sources.

At the System Setup Menu select “Digital Inputs”.

Switch to the Digital Inputs screen.

Select the digital input jack to be assigned to the input source.

• To select the input source

• To select the digital input jack

Select “OFF” for input sources for which no digital input jacks are used.

If “Yes” is selected for “Default”, the settings are automatically reset to the default values.

Enter the setting.

The System Setup Menu reappears.

ENTER

NOTES:

• The OPTICAL 5 jacks on the AVR-5700’s rear panel are equipped with an optical digital output jack for recording digital signals on a DAT

deck, MD player or other digital recorder. Use this for digital recording between a digital audio source (stereo - 2 channel) and a digital audio

recorder.

• Do not connect the output of the component connected to the OPTICAL 5 OUT jack on the AVR-5700’s rear panel to any jack other than

the OPTICAL 5 IN jack.

• “PHONO”, “TAPE-2” and “TUNER” cannot be selected on the Digital Inputs screen.

1 2 ... 20 21 22 23 24 25 26 27 28 29 30 ... 63 64

No comments

Denon AVR-5700 User Manual Page 25