Denon AVR-5700 User Manual Page 28

  • Download
  • Add to my manuals
  • Print
  • Page
    / 64
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 27
28
8
REMOTE CONTROL UNIT
The included remote control unit (RC-853) can be used to operate not only the AVR-5700 but other remote control compatible DENON
components as well. Furthermore, it is equipped with a function for learning the control signals of remote control units of other manufacturers,
so it can also be used to operate non-DENON remote control compatible video components.
Inserting the batteries
1 Remove the remote control unit’s rear cover.
2 Set two SUM3 (AA size) batteries in the battery compartment in
the indicated direction.
3 Put the rear cover back on.
Notes on Batteries
Use SUM3 (AA size) batteries in the remote control unit.
The batteries should be replaced with new ones approximately
once a year, though this depends on the frequency of usage.
Even if less than a year has passed, replace the batteries with new
ones if the set does not operate even when the remote control
unit is operated nearby the set.
When inserting the batteries, be sure to do so in the proper
direction, following the “< ” and “> ” marks in the battery
compartment.
To prevent damage or leakage of battery fluid:
Do not use a new battery together with an old one.
Do not use two different types of batteries.
Do not short-circuit, disassemble, heat or dispose of batteries in
flames.
Remove the batteries from the remote control unit when you do
not plan to use it for an extended period of time.
If the battery fluid should leak, carefully wipe the fluid off the
inside of the battery compartment and insert new batteries.
When replacing the batteries, have the new batteries ready and
insert them as quickly as possible.
The learned remote control signals may be cleared if no batteries
are in the remote control unit for about 5 seconds.
The factory-installed codes are in permanent memory, however.
Using the remote control unit
Approx. 7 m/22 feet
Point the remote control unit at the remote sensor on the main
unit as shown on the diagram.
The remote control unit can be used from a straight distance of
approximately 7 meters/22 feet from the main unit, but this
distance will be shorter if there are obstacles in the way or if the
remote control unit is not pointed directly at the remote sensor.
The remote control unit can be operated at a horizontal angle of up
to 30 degrees with respect to the remote sensor.
NOTES:
It may be difficult to operate the remote control unit if the remote
sensor is exposed to direct sunlight or strong artificial light.
Do not press buttons on the main unit and remote control unit
simultaneously. Doing so may result in malfunction.
Neon signs or other devices emitting pulse-type noise nearby may
result in malfunction, so keep the set as far away from such
devices as possible.
Page view 27
1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 63 64

Comments to this Manuals

No comments