Denon AVR-5700 User Manual download pdf (Page 6)

CONNECTIONS

• Do not plug in the AC cord until all connections have been completed.

• Be sure to connect the left and right channels properly (left with left, right with right).

• Insert the plugs securely. Incomplete connections will result in the generation of

noise.

• Use the AC OUTLETS for audio equipment only. Do not use them for hair

driers, etc.

• Note that binding pin plug cords together with AC cords or placing them near a

power transformer will result in generating hum or other noise.

• Noise or humming may be generated if a connected audio equipment is used

independently without turning the power of this unit on. If this happens, turn on the

power of the this unit.

Connecting the audio components

A+B

OUT

PREOUT

6 16

PHONO

FRONT

CENTER

EFECT

SURROUND

SIGNAL

GND

DVD

VDP

DBS

V.AUX

VCR

TAPE-1

TAPE-2

MONITOR

SOURCE

MULTI

OUT-1

MONITOR

OUT-2

DVD

VDP

DBS

V.AUX

VCR

TAPE-1

TAPE-2

6CH EXT. IN

8CH EXT. IN AUDIO VIDEO S-VIDEO DIGITAL

SUB

WOOFER

R L

DVD TV/DBS

COMPONENT VIDEO

SPEAKER SYSTEMS

OPTICAL

COAXIAL

DOLBY DIGITAL

OPTICAL-5

123

SWITCHED TOTAL 120W(1A.) MAX.

AC 120V 60Hz

AC OUTLETS

AC IN

FRONT

CENTER

R L

SURROUND

SPEAKER

IMPEDANCE

FRONT,CENTER

6 16

12 16

SURROUND

A OR B

MONITOR

ROOM TO ROOM

REMOTE

CONTROL

CR YCB CR YCB CR

IN IN

LOOP

ANT.

COAX.

ANTENNA TERMINALS

RLRL

OUTPUT INPUT

DIGITAL AUDIODIGITAL AUDIO

OUTPUT INPUT

LRL

DIGITAL AUDIODIGITAL AUDIO

OUTPUT

RLRL

OUTPUT INPUT

OPTICAL COAXIAL

OUTPUT

OPTICAL

CD player

Turntable

(MM cartridge)

Tape deck 1 or MD

NOTE:

This unit cannot be used with MC cartridges

directly. Use a separate head amplifier or

step-up transformer.

Connecting a CD player

Connect the CD player’s analog output jacks

(ANALOG OUTPUT) to this unit’s CD jacks

using pin plug cords.

AC 120 V, 60 Hz

AC OUTLETS

• SWITCHED

(total capacity – 120 W (1 A.))

The power to these outlets is turned on and off in conjunction with the POWER

switch on the main unit, and when the power is switched between on and

standby from the remote control unit.

No power is supplied from these outlets when this unit’s power is at standby.

Never connect equipment whose total capacity is above 120 W (1 A.)

NOTE:

Only use the AC OUTLETS for audio equipment. Never use them for hair driers,

TVs or other electrical appliances.

Connecting the AC OUTLETS

Connecting a tape deck

AC outlets (wall)

Connecting the DIGITAL jacks

Use these for connections to audio equipment with digital output.

Refer to page 25 for instructions on setting this terminal.

NOTES:

• Use 75 Ω/ohms cable pin cords for coaxial connections.

• Use optical cables for optical connections, removing the cap

before connecting.

Ground wire

AC cord (included)

MD player, DAT deck or other component

equipped with digital input/output jacks

CD player or other component

equipped with digital output jacks

Tape deck 2

• When making connections, also refer to the operating instructions of the other components.

Pre-main (integrated) amplifier

for multi-source playback

Connecting a turntable

Connect the turntable’s output cord to the AVR-

5700’s PHONO jacks, the L (left) plug to the L

jack, the R (right) plug to the right jack.

If humming or other noise is

generated when the ground wire

is connected, disconnect the

ground wire.

NOTE:

Refer to page 10 for notes

on the shorting pin plugs.

Connecting the pre-out jacks

Use these jacks if you wish to connect external power amplifier(s) to

increase the power of the front, center and surround sound channels, or

for connection to powered loudspeakers. For instructions on using the

effect output, refer to page 41.

Extension jacks for future use

Route the connection cords, etc., in such a way that

they do not obstruct the ventilation holes.

Connections for recording:

Connect the tape deck’s recording input jacks (LINE IN or REC) to this unit’s

tape recording (OUT) jacks using pin plug cords.

Connections for playback:

Connect the tape deck’s playback output jacks (LINE OUT or PB) to this unit’s

tape playback (IN) jacks using pin plug cords.

1 2 3 4 5 6 7 8 9 10 11 ... 63 64

Comments to this Manuals

No comments

Denon AVR-5700 User Manual Page 6

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-5700