Denon AVR-590 User Manual Page 49

  • Download
  • Add to my manuals
  • Print
  • Page
    / 67
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 48

ENGLISH
Getting Started
Connections Playback Information Troubleshooting
SpecificationsSettings
1
Switch to the device to be operated.
TUNER/AMP
: To operate a Tuner
DEVICE
: To operate a Blu-ray disc player, DVD player,
CD player,
Digital video recorder, Video deck,
iPod, Satellite receiver or cable TV
MAIN/TV
: To operate a TV
2
When “DEVICE” has been selected in step 1, press
the source select button for the device to be operated.
The remote control unit is set to the device mode for the device
to be operated. When the remote control transmitter is pointed
towards the AVR-590 at this time, the AVR-590’s input source
switches simultaneously.
b The remote control unit stays in the same device mode until a
different source select button is pressed.
3
Operate the component.
b For details, refer to the component’s operating instructions.
Operating the Connected Devices by Remote Control Unit
Some manufacturers use more than one type of remote control code.
Refer to the included list of preset codes to change the number and
verify correct operation.
The preset memory can be set for one component only among the
following: DVD/CD and SAT/CBL.
Registering Preset Codes
DENON and other makes of components can be operated by
setting the preset memory.
Operating Registered Devices
NOTE
Depending on the model and year of manufacture, this function cannot
be used for some models, even if they are of makes listed in the list
of preset codes.
Operation
mode setting
ON/SOURCE
Power on / Standby
z
1
1
Play / Pause
2
Stop
3
Pause
MEMORY
MEMORY
z
1
TOP MENU
Calling out the top menus
z
1
6 7
Manual search
(fast-reverse / fast-forward)
8 9
Auto search
(cue)
uio p
Cursor
ENTER Enter
SEARCH
Press and
hold
Once
Browse/Remote
mode switching
Page search
mode switching
z
2
RETURN Return
PAGE d f
Page up/down
z
1
z
1 : This operation is possible when using a
DENON ASD-3N or ASD-3W Control Dock
for iPod.
z
2 : This operation is possible when using a
DENON ASD-1R or ASD-11R Control Dock
for iPod.
iPod
Operating Registered Devices
1
Press the source select button (see
below) for the device to be registered
and simultaneously for over 2
seconds.
“RC SETUP START” appears on the display
and the remote control unit is set to the
preset code registration mode.
: TV : Digital video recorder
:
DVD player
or CD player
: Video deck
: Blu-ray disc player
:
Satellite receiver
or cable TV
2
Press ~ and input the
3-digit number of the brand of
the component to be preset. The
numbers are shown in the Preset
Code Table (vEnd of this
manual).
When registration is completed, “RC SETUP OK” appears on
the display.
b If the codes could not be registered, “RC SETUP NG” appears on
the display. Try again.
3
To store the codes of another component in the
memory, repeat steps 1 to 2.
b For details, refer to the component’s operating instructions.
n Cautions during operation
When registering a preset code, point the remote control transmitter
toward the AVR-590. The status of the registration operation is
displayed on the AVR-590.
Remote Control
Page view 48
1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 66 67

Comments to this Manuals

No comments