Denon SC-CX303 User Manual download pdf (Page 6)

Connections Connections

ENGLISH

¢ Connecting to an amplifier with two sets of

speaker outputs (A+B)

• Set the speaker output selector switch to “A+B”.

Bi-wiring connections

The speaker system (SC-CX303) input terminals and circuitry allows

bi-wiring connections with the treble (upper tier) and bass (lower tier)

isolated and independent. This enables playback of high quality sound

without the audio signal interference resulting from the difference in

level between the treble and bass.

Use two connection cords per SC-CX303 unit.

Remove the short-circuit cords from the “+” and “–” sides.

¢ Connecting to an amplifier with only one set of

speaker outputs

• Also use this procedure to connect to amplifiers on which it is not

possible to output A and B simultaneously even if the amplifier

has two sets of outputs, or amplifiers on which the two sets of

outputs are connected in series.

To speaker “+” terminal

Twist the tip firmly

To speaker “–” terminal

• The SC-CX303’s impedance does not change even when using with

bi-wiring connections.

• For even more advanced enjoyment, if you have two amplifiers you

can set up a bi-amp drive system. In this case, set the outputs of the

two amplifiers to the same level.

CAUTION:

• If the amplifiers have different output levels, only the treble or

the bass will be emphasized and it will be impossible to achieve

the optimum balance between the two.

ENGLISH

Tweeter terminals

Woofer terminals

Connect to amplifier’s A speaker “+” side.

Connect to amplifier’s

A speaker “–” side.

Connect to amplifier’s

B speaker “+” side.

Connect to amplifier’s

B speaker “–” side.

1 2 3 4 5 6 7 8

No comments

Denon SC-CX303 User Manual Page 6