Denon DP-29F User Manual download pdf (Page 6)

ENGLISH

BEFORE USING THE TURNTABLE

Rubber mat

Spindle

Ribbon tape

Driving roller

Drive belt

Equalizer Amplifier switch

This unit has built-in RIAA equalizer amplifier, so it can be

connected to an amplifier without PHONO (turntable) input

jack. According to the amplifier, set the EQUALIZER

AMPLIFIER SWITCH.

When the unit is connected

to the PHONO (MM) jacks:

Rear panel of the

amplifier

PHONO

OFF

White

Red

When the unit is connected

to the AUX jacks, etc:

Rear panel of the

amplifier

AUX

OFF

White

Red

• The drive belt is fitted under the platter. When assembling the

player, please handle the drive belt with care.

• Remove all packing materials attached to the tone arm, except

that on the stylus, and then open the dust cover and assemble.

Remove the stylus cover after assembling.

Hold the platter by the holes at its outer surface, and

then carefully lower the platter so that the center

spindle enters the center hole.

Rotate the platter until one of its outer openings is

aligned with the driving roller. (Refer to illustration.)

Gently grasp and pull at the ribbon tape of the drive

belt that is would under the turntable, and then

extend the belt around the driving roller. (After

attaching, remove the ribbon tape.)

In order to make sure that the drive belt has been

correctly fitted, slowly rotate the platter 3 or 4 turns.

Place the rubber mat on the platter.

IMPORTANT! Please Check.

Check that the drive belt and ribbon tape have been attached

under the platter. Grasp the ribbon tape as shown in the

illustration to the left, and extend it onto the driving roller.

1 2 3 4 5 6 7 8 9 10 11

Comments to this Manuals

No comments

Denon DP-29F User Manual Page 6

Comments to this Manuals

Related products and manuals for Recorders Denon DP-29F