Denon DA-300USB Owner's Manual download pdf (Page 21)

Appendix

TipsSettingsConnections

Contents

Front panel Display Rear panel Index

Playback

2 Playback

•Install the desired player software on your computer beforehand.

•Use the rear panel USB-DAC port to connect this unit to a computer.

For the connection procedure, refer to the “Connecting devices”

(vpage11) section.

Touch to change the input source to “USB-DAC”.

Start playback on the computer’s player software.

The digital audio signal that is being input is shown as

follows in the display.

“PCM

xxxxxkHz”

“DSD

xxxxxMHz”

(xxxxx is the sampling frequency.)

•If the sampling frequency cannot be detected, “Unlock” will be

displayed.

•“Unsupported” is displayed when audio signals that are not

supported by this unit are input.

2 Files that can be played back

See “Input signals available for USB-DAC playback” (vpage29).

NOTE

•Perform operations such as playback and pause on the computer.

•You can also control the volume and equalizer on the computer. Enjoy playing

music at the desired volume.

•No audio is output from the speakers of your computer while this unit is in

operation.

•If the computer is disconnected from this unit while the computer music playback

software is running, the playback software may freeze. Always exit the playback

software before disconnecting the computer.

•When an abnormality occurs on the computer, disconnect the USB cable and

restart the computer.

•The sampling frequency of the music playback software and sampling frequency

displayed on this unit may dier.

•Use a cable that is 3 m or less to connect to the computer.

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 34 35

No comments

Denon DA-300USB Owner's Manual Page 21