Denon DP-A100 Service Manual download pdf (Page 4)

NOTE FOR SCHEMATIC DIAGRAM

WARNING:

Parts marked with this symbol

have critical characteristics. Use ONLY replacement parts recommended by the manufacture

CAUTION:

Before returning the unit to the customer, make sure you make either (1) a leakage current check or (2) a line to chassis resistance check. If the

leakage current exceeds 0.5 milliamps, or if the resistance from chassis to either side of the power cord is less than 460 kohms, the unit is defective.

WARNING:

DO NOT return the unit to the customer until the problem is located and corrected.

NOTICE:

ALL RESISTANCE VALUES IN OHM. k=1,000 OHM / M=1,000,000 OHM

ALL CAPACITANCE VALUES IN MICRO FARAD. P=MICRO-MICRO FARAD EACH VOLTAGE AND CURRENT ARE MEASURED AT NO SIGNAL

INPUT CONDITION. CIRCUIT AND PARTS ARE SUBJECT TO CHANGE WITHOUT PRIOR NOTICE.

Parts for which "nsp" is indicated on this table cannot be supplied.

When ordering of part, clearly indicate "1" and "I" (i) to avoid mis-supplying.

Ordering part without stating its part number can not be supplied.

Not including General-purpose Carbon Chip Resistor in the P.W.Board parts list. (Refer to the Schematic Diagram for those parts.)

Parts marked with this symbol z have critical characteristics. Use ONLY replacement parts recommended by the manufacturer.

Not including General-purpose Carbon Film Resistor in the P.W.Board parts list. (Refer to the Schematic Diagram for those parts.)

Part indicated with the mark "★" is not illustrated in the exploded view.

WARNING:

● Resistors

RD : Carbon

RC : Composition

RS : Metal oxide film

RW: winding

RN : Metal film

RK : Metal mixture

P : Pulse-resistant type

NL : Low noise type

NB : Non-burning type

FR : Fuse-resistor

F : Lead wire forming

2B : 1/8 W

2E : 1/4 W

2H : 1/2 W

3A : 1 W

3D : 2 W

3F : 3 W

3H : 5 W

F:±1%

G:±2%

J:±5%

K:±10%

M:±20%

Ex.: RN

Type

14K

Shape

and per-

formance

Power

182

Resist-

ance

Allowable

error

Others

* Resistance

1800ohm=1.8kohm1 8

Indicates number of zeros after effective number.

2-digit effective number.

1.2ohm1 R 2

2-digit effective number, decimal point indicated by R.

1-digit effective number.

: Units: ohm

●

Capacitors

CE : Aluminum foil

electrolytic

CA : Aluminium solid

electrolytic

CS : Tantalum electrolytic

CQ : Film

CK : Ceramic

CC : Ceramic

CP : Oil

CM: Mica

CF : Metallized

CH : Metallized

HS : High stability type

BP : Non-polar type

HR : Ripple-resistant type

DL : For change and discharge

HF : For assuring high requency

U : UL part

C : CSA part

W : UL-CSA part

F : Lead wire forming

0J : 6.3 V

1A : 10 V

1C : 16 V

1E : 25 V

1V : 35 V

1H : 50 V

2A : 100 V

2B : 125 V

2C : 160 V

2D : 200 V

2E : 250 V

2H : 500 V

2J : 630 V

F:±1%

G:±2%

J:±5%

K:±10%

M:±20%

Z:±80%

: - 20%

P : +100%

C:±0.25pF

D:±0.5pF

= : Others

Ex.: CE

Type

04W

Shape

and per-

formance

Dielectric

strength

3R2

Capacity

Allowable

error

Others

･ Units:μF.

2200μF2 2

Indicates number of zeros after effective number.

2-digit effective number.

･ Units:μF.

2.2μF2 R

2-digit effective number, decimal point indicated by R

1-digit effective number.

* Capacity (electrolyte only)

･ When the dielectric strength is indicated in AC,"AC" is included after the dieelectric strength value.

* Capacity (except electrolyte)

･ Units:pF

2200pF=0.0022μF2 2

Indicates number of zeros after efective number. (More than 2)

2-digit effective number.

･ Units:pF

220pF2 2

2-digit effective number.

Indicates number of zeros after effective numver. (0 or 1)

NOTE FOR PARTS LIST

1 2 3 4 5 6 7 8 9 ... 30 31

Comments to this Manuals

No comments

Denon DP-A100 Service Manual Page 4

Comments to this Manuals

Related products and manuals for Turntable Denon DP-A100