Denon AVR-X1100W Owner's Manual download pdf (Page 172)

Error messages

An error message is displayed if Audyssey

Setup could not be completed due to speaker placement, the measurement environment, etc. If an error

message is displayed, check the relevant items and perform the necessary measures. Be sure to turn off the power before checking speaker connections.

Examples Error details Measures

No speakers found.

Sound calibration microphone is not

detected.

Connect the included Sound calibration microphone to the

SETUP MIC jack of this unit.

Not all speakers could be detected.

Check the speaker connections.

Ambient noise is too high or level is too

low

There is too much noise in the room.

Either turn off any device generating noise or move it away.

Perform again when the surroundings are quieter.

Speaker or subwoofer sound is too low.

Check the speaker installation and the direction in which the

speakers are facing.

Adjust the subwoofer’s volume.

Front R : None

The displayed speaker could not be

detected.

Check the connections of the displayed speaker.

Front R : Phase

The displayed speaker is connected with the

polarity reversed.

Check the polarity of the displayed speaker.

For some speakers, this error message may be displayed

even if the speaker is properly connected. If you are sure the

connection is correct, press p to select “Ignore”, then press

ENTER.

Contents Connections Playback Settings Tips Appendix

172

Front panel Display Rear panel Remote Index

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 258 259

No comments

Denon AVR-X1100W Owner's Manual Page 172