Denon DRM-555 Operations Instructions download pdf (Page 10)

ENGLISH

RECORDING

q Press the Power Operation switch to the ¢ ON position.

w Load the cassette tape.

(Check that the erasure prevention tabs of the cassette housing have not

been broken off.)

e Move the Dolby NR switch (DOLBY NR) and select the Dolby NR type that

suits the recording.

B OFF C

DOLBY NR

r Press the Direction button ( 01) to select the direction of tape transport.

t Select the type of tape transport with the Reverse Mode switch (REV.

MODE).

Switch positionMode

To record on only one side

To continuously record

on both sides

y Press the Rec/Rec Mute button (REC/REC MUTE) ( 4 ) to set the recording

pause mode. The

43indicator will light up.

u Adjust the recording level with the Input Level control (INPUT LEVEL)

while watching the Peak Level Meter.

i Press the Play button (PLAY) to start the recording.

The play ( or ) and the

4 indicator will light during recording.

o To pause the recording, press the Rec Pause button (

3 REC PAUSE).

Press the Play button (PLAY) to resume recording.

!0 To stop recording, press the Stop button (

2 STOP).

Caution:

• Be careful not to erase important recordings by mistake. Inadvertent start of

recording will happen in the following cases:

1. If the Play button (PLAY) is pressed while the

4 indicator lights, recording

starts.

If the Play button (PLAY) and Rec/Rec Mute button (REC/REC MUTE)

( 4 ) are pressed at the same time, recording starts.

The best way to avoid accidental erasure is to break off the two erasure

prevention tabs on the cassette housing.

2 PROPER RECORDING LEVEL

A too high recording level can saturate the tape and cause distortion. On the

other hand, if the recording level is set too low, soft passages will be

marked by residual noise. A proper recording level is the single most

important factor for making well balanced recordings.

Guideline for maximum recording level

0 dB level on peaks

+1 dB level on peaks

+3 dB level on peaks

TYPE

I (Normal)

TYPE II (CrO2)

TYPE IV (Metal)

Note: The optimum recording level differs depending on the program source

and the type of tape used.

• Switch on your amplifier or receiver and the source component.

• Set the Tape Monitor switch on your amplifier or receiver to the SOURCE position.

PRECISION AUDIO COMPONENT/CASSETTE TAPE DECK DRM-555

REMOTE SENSOR

-40 +10-30 +5-20 +3-10 +1-5 0-3 -1

‚¤‚‚

PLAY

2 STOP 3 REC PAUSE

REC/REC MUTE

PHONES

RESET

INPUT LEVEL

EJECT

¢ON £OFF

COUNTER

MEMORY

MPX

B OFF C

DOLBY NR

REC OFF PLAY.

TIMER

REV.MODE

PHONE LEVEL

MIN MAX

+ LEFT RIGHT

BIAS FINE BALANCE

DIRECTION

CD SYNCHRO REC

AUTO REVERSE

HIGH SPEED DUBBING SYSTEM

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 21 22

Comments to this Manuals

No comments

Denon DRM-555 Operations Instructions Page 10

Comments to this Manuals