Denon AVR-2809CI User Manual download pdf (Page 16)



Getting Started Setup Playback Remote Control Multi-zone Information Troubleshooting Speciﬁcations

"4%/8

"6%*0

$0"9*"-

065

(/%

"6%*0

065

Record Player

• When connecting a record player with an MC cartridge, use a

commercially available MC head ampliﬁer or a step-up transformer.

• Induction humming (a booming sound) may be produced from the

speakers if the volume is raised with no record player connected.

• With some record players, noise may be generated when the ground

wire is connected. If so, disconnect the ground wire.

• When using a record player with a built-in phono equalizer, set the

phono equalizer to “OFF”.

Turntable (MM cartridge)

NOTE

The AVR-2809CI’s SIGNAL GND terminal is meant to reduce noise when

a record player is connected. This is not a safety ground terminal.

CD Player

CD player

When using an optical cable for the digital audio connection, make the

settings at menu “Input Setup” – “Assign” – “Digital In” (vpage

38).

iPod

• With the default settings, the iPod can be used connected to the

VCR (iPod) connector.

• To assign the iPod to a connector other than VCR (iPod), make the

settings at menu “Input Setup” – “(input source to which iPod dock

assigned)” – “Assign” – “iPod Dock” (vpage 39).

Use a DENON control dock for iPod (ASD-1R, ASD-11R, ASD-3N or

ASD-3W sold separately) to connect the iPod to the AVR-2809CI. For

instructions on the control dock for iPod settings, refer to the control

dock for iPod’s operating instructions.

Connections

1 2 ... 11 12 13 14 15 16 17 18 19 20 21 ... 101 102

No comments

Denon AVR-2809CI User Manual Page 16