37
4
Use the D and H cursor buttons to display “RESET SYS” on
the remote control unit, then press the ENTER button.
•“SYS SEL” appears on the remote control unit’s display.
The remote control unit’s display switches as shown
below each time the D and H cursor buttons are pressed.
q To reset CALL 1 or CALL 2, select “SYS CALL 1” or SYS
CALL 2”, then press the ENTER button.
w To reset system call settings registered at other buttons,
select “SYS MODE”, press the ENTER button, press the
mode button at which the button is registered, then press
the ENTER button again.
6
“CONFIRM” is displayed. To reset the setting, press the
ENTER button while “CONFIRM” is displayed.
•“SYS SEL” appears on the remote control unit’s display.
Press the power ON/SOURCE button and the OFF button at
the same time.
•“SET UP” appears on the remote control unit’s display.
Press the ENTER button.
Use the D and H cursor buttons to display “RESET” on the
remote control unit, then press the ENTER button.
5
Press the D and H cursor buttons to select the system call
setting to be reset.
The remote control unit’s display switches as shown
below each time the D and H cursor buttons are pressed.
Comments to this Manuals