Denon POA-3012CI User Manual download pdf (Page 12)



Getting Started Setup Operations Troubleshooting

ENGLISH

Speciﬁcations

RS-232C connector

This connector is used for an external controller.

b If you wish to control the POA-3012CI from

an external controller using the RS-232C

connector, perform the operation below

beforehand.

q Turn the POA-3012CI’s power.

w Turn off the POA-3012CI’s power from the

external controller.

e Check that the POA-3012CI is in the standby

mode.

Trigger output jack

The power of an external device equipped with

a trigger input jack can be turned on and off in

association with operations on the POA-3012CI.

• Output level: 250 mA / 12 V

Check the trigger input conditions of the

connected device.

• If the trigger input level of the connected device

is higher than 250 mA / 12 V and depending on

the short-circuiting conditions, the POA-3012CI’s

protection circuit may be activated, in which

case “TRIGGER OUT OVER LOAD” appears on

the display. If this happens, turn off the POA-

3012CI’s power and disconnect the connected

device.

External Controller

Master trigger input jack

The “POWER CONFIGURATION” setting is valid

at the time of a “MASTER TRIGGER”.

Voltage input to the MASTER TRIGGER input

terminal and operating status of the POA-3012CI:

At DC 3 ~ 30 V ···················· ON

At DC 0 V ···························· STANDBY

ZONE trigger input jack

The ZONE TRIGGER ON MODE setting is valid at

the time of a “TRIGGER IN”.

Voltage input to the TRIGGER IN input terminal

and operating status of the power ampliﬁer of

each ZONE:

At DC 3 ~ 30 V ···················· ON

At DC 0 V ···························· STANDBY

Connections

1.POA-3012CI_ENG_101.indd 9 2008/07/30 14:08:22

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 22 23

Comments to this Manuals

No comments

Denon POA-3012CI User Manual Page 12

Comments to this Manuals

Related products and manuals for Audio amplifiers Denon POA-3012CI