Denon DN-700H Owner's Manual download pdf (Page 35)

Getting started Connections

Basic operations Advanced OperationsAdvanced operations TroubleshootingExplanation termsInformation Speciﬁcations Index

EnGlisH

Setting the network [Network]

•For details on “Network First Setup” (vpage10).

•If you cancelled “Network First Setup” menu or changed the

network environment, perform “Menu” – “Network” – “Network

First Setup”.

Connecting wired LAN

Use this procedure to conﬁgure the wired LAN settings.

n Network connecting

(when “DHCP”settings are “On”)

When using this unit with the broadband router’s DHCP function

enabled, this unit automatically performs the IP address setting

and other settings.

Connect the ETHERNET cable (vpage 7

“Connecting to a network (LAN)”).

Press ON/STANDBY to turn on power to the main

unit.

Press [MENU].

Turns on the Menu settings mode and the Menu appears on

the display (vpage28 “Menu map”).

Use ui to select “Network” – “Connection” –

“DHCP (On)”, then press [ENTER], <1/3

ENTER

or p.

“Select DHCP” menu appears.

Use ui to select “On”, then press [ENTER],

<1/3

ENTER

> or p.

“Setup Wired” menu appears.

Use ui to select “Connection”, then press [ENTER],

<1/3

ENTER

> or p.

“Connecting” is displayed, and the unit starts connecting to

the LAN.

•When the connection is made successfully, “Succeeded” appears.

•If the connection cannot be established, “Connection Failed” is

displayed. Perform steps 1 – 5 again.

You may need to set the network connection manually, depending

on the provider you use. To set the connection manually, use the

setting procedure of “Network connecting (when “DHCP” settings

are “Off”)”.

n Network connecting

(when “DHCP” settings are “Off”)

This section explains the settings when connecting this unit to a

network that does not have a DHCP function.

To conﬁgure the settings manually, check the setting details with

your network administrator.

Perform steps 1 – 4 of the “Network connecting

(when “DHCP”settings are “On”)” procedure and

select “Off” in step 5.

“Select DHCP” menu appears.

Use ui to select “IP Address”, then press [ENTER],

<1/3

ENTER

> or p.

“Input IP Address” menu appears.

Use uip or [NUMBER] (0 – 9) to input the IP

address and press [ENTER] or <1/3

ENTER

Use uip or [NUMBER] (0 – 9) to input the address

for “Subnet Mask”, “Gateway”, “Primary DNS”,

and “Secondary DNS”.

Use ui to select “Connection”, then press [ENTER],

<1/3

ENTER

> or p.

“Connecting” is displayed, and the unit starts connecting to

the LAN.

•When the connection is made successfully, “Succeeded” appears.

•If the connection cannot be established, “Connection Failed” is

displayed. Perform steps 1 – 4 again.

Button located on both the main unit and the remote control

BUTTON

Button only on the main unit

Button only on the remote control

[BUTTON]

Symbols used to indicate buttons in this manual

<1/3 ENTER>

ON/STANDBY

ui p

[ENTER]

[MENU]

[NUMBER]

(0 – 9, +10)

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 63 64

Comments to this Manuals

No comments

Denon DN-700H Owner's Manual Page 35

Comments to this Manuals