Denon AV Surround Receiver AVR-5803 Operations Instructions download pdf (Page 29)

CAUTION!

• The master volume is set to "-30 dB" when test tones are output

• The test tones are for confirming the low frequency playback limits and are played at an extremely high level When using a low output

subwoofer, be very careful about irregular operations exceeding clipping by for example turning down the subwoofer's attenuator before

starting then slowly turning the attenuator up to the listening level.

• Also, when the subwoofer is set to "NO" in the speaker configuration, the test tones are output from the front speakers When using front

speakers with low input resistance, check that the sound is not clipped at sections where the signal is strong on the CD music source before

starting the peak limit setting The peak limit setting should not be performed if the music source cannot be played with the master volume

set at "-15" Set the front speakers to "small" and the subwoofer to "YES" in the speaker configuration. When this is done, the low

frequencies are cut, so the effect is insufficient. We strongly recommend adding a subwoofer.

• If the test tone is clipped when it is set to "-18 dB", set the peak limit to "-18 dB" ]n this case, the input resistance of the subwoofer or

front speakers is insufficient so clipping may occur when playing music. We recommend switching to a subwoofer with a higher input

resistance

• This setting assigns the digital input iacks of the AVR_5803 for the different input sources

At the System Setup Menu select "Digital In Assignment".

System Setup Menu

Speaker Configuration

Delay Time

Channel Level

THX Audio Setup

S=bw00ferPeak Limit Lev.

_Digital In Assignment

Video Input Mode

R=_eel=

Switch to the Digital In Assignment screen.

Digital In Assignment

ut3_:_COAX1_ [_]: COAX5

[_: COAX2 _: OPT5

[_)_: COAX3 [_: OPT6

[_: OPT1

[_: OPT2

[_: OPT3 Default[_

[_: OPT4

[_: COAX4

t Select the digital input jack to be assigned to the input source.

,_m= _ • To select the input source

,.w.,

• To select the digital input jack

i Select "OFF" for input sources for which no digital input jacks are used.If "Yes" is selected for "Default", the settings are automatically reset to the default values.

.=m= Enter the setting

q,_ The System Setup Menu reappears.

NOTES:

• The OPTICAL 5 and 6 iacks on the AVR-5803's rear panel are equipped with an optical digital output jack for recording digital signals on a

DAT deck, MD recorder or other digital recorder Use this for digital recording between a digital audio source (stereo _2 channel) and a digital

audio recorder

• Do not connect the output of the component connected to the OPTICAL 5 OUT jack on the AVR_5803's rear panel to any jack other than the

OPTICAL 5 IN jack.

• Do not connect the output of the component connected to the OPTICAL 6 OUT jack on the AVR_5803's rear panel to any jack other than the

OPTICAL 6 IN iack.

• "PHONO" and "TUNER" cannot be selected on the Digital In Assignment screen.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 83 84

Comments to this Manuals

No comments

Denon AV Surround Receiver AVR-5803 Operations Instructions Page 29

Comments to this Manuals

Related products and manuals for AV receivers Denon AV Surround Receiver AVR-5803