Denon AVR-1513 Owner's Manual download pdf (Page 58)

GAudioH

Symptom Cause/Solution Page

Audio is not output. •Check the connections for all devices.

•Check the speaker connections and conﬁgurations.

•Check whether the audio device power is turned on.

•Adjust the master volume.

•Cancel the mute mode.

•Select a suitable input source.

•Select a suitable input mode.

•Disconnect the headphones. No sound is output from the

speakers when headphones are connected.

C 4,

6,7,10,11,

12,13

C 3,

25,26

–

The volume does not

increase.

•The maximum volume is set too low. Set the maximum volume

using “Limit” on the menu.

•Power for external devices connected to the output connectors

of the unit may not be turned on. Check the power of connected

external devices.

–

No sound is

produced from

surround speaker.

•Check if the surround speakers are connected to the SURROUND

terminals.

–

No sound is

produced from

subwoofer.

•Check the subwoofer connections.

•Turn on the subwoofer’s power.

•Set “Speaker Conﬁg.” – “Subwoofer” on the menu to “Yes”.

•If “Front” and “Center” for “Speaker Conﬁg.” are set to “Large”,

and “SW Mode” is set to “LFE”, no sound may be output from

the subwoofers, depending on the input signal or selected

surround mode.

C 3,

25,26

C 4

C 6

C 5,

C 6

DTS sound is not

output.

•Set “Decode Mode” on the menu to “Auto” or “DTS”.

Dolby TrueHD, DTS-

HD, Dolby Digital

Plus audio is not

output.

•Make HDMI connections.

Dolby PLg mode or

DTS NEO:6 mode

cannot be selected.

•Check that “Speaker Conﬁg.” – “Center” or “Surround” is set

to other than “None”. If the speaker system is 2.0/2.1ch, this

surround mode cannot be selected.

•When headphones are used, Dolby PLg or DTS NEO:6 cannot be

selected.

C 5

–

RESTORER cannot

be selected.

•Check that an analog signal or PCM signal (fs=44.1/48 kHz) is

input. For playback of multichannel signals such as Dolby Digital

or DTS surround, RESTORER cannot be used.

GRadioH

Symptom Cause/Solution Page

Reception fails, or

there is a lot of noise

or distortion.

•Change the antenna orientation or position.

•Separate the AM loop antenna from the unit.

•Use an FM outdoor antenna.

•Separate the antenna from other connection cables.

GRemote Control UnitH

Symptom Cause/Solution Page

The set cannot be

operated with the

remote control unit.

•Batteries are worn out. Replace with new batteries.

•Operate the remote control unit within a distance of about 7 m

from this unit and at an angle of within 30°.

•Remove any obstacle between this unit and the remote control

unit.

•Insert the batteries in the proper direction, checking the q and

w marks.

•The set’s remote control sensor is exposed to strong light (direct

sunlight, inverter type ﬂuorescent bulb light, etc.). Move the set

to a place in which the remote control sensor will not be exposed

to strong light.

Basic version

Advanced version

InformationInformation

1 2 ... 53 54 55 56 57 58 59 60 61 62

Comments to this Manuals

No comments

Denon AVR-1513 Owner's Manual Page 58

Comments to this Manuals

Related products and manuals for AV receivers Denon AVR-1513