Denon AVR-2105 Operations Instructions download pdf (Page 21)

Before setting up the system

Press the SYSTEM SETUP button to enter the setting.

Press the ENTER or (down) button to switch to the Auto Setup.

*SYSTEM SET UP

NOTE:

Press the SYSTEM SETUP button again to finish system set up. System set up can be finished at any time. The changes to the settings made

up to that point are entered.

NOTE: Please make sure the “AUDIO” position of the slide switch

on the remote control unit.

ON / STANDBY

Turn on the power.

Press the Power ON/STANDBY switch (button).

(Main unit) (Remote control unit)

ON OFF

Press the Power switch (button) .

(Main unit)

• ¢ ON

The power turns on and indicator is light.

Set the power switch to this position to turn the power on and off from the included remote control unit.

• £ OFF

The power turns off and indicator is off.

In this position, the power cannot be turned on and off from the remote control unit.

Refer to “CONNECTIONS” (pages 7 to 15) and check that all connections are correct.

Auto setup

The Auto Setup function of this unit performs an analysis of the speaker system to permit an appropriate automatic setting.

When performing Auto Setup, an optional microphone is required for the setup.

2 Measurement and setting details

q : This sets the speaker connection mode, polarity, and bass reproduction ability.

w : This sets the optimum delay time from each speaker corresponding to the listening position.

e : This sets the volume that is output from each speaker.

NOTE:

•A loud test tone is output during the measurement. Please consider this should you be planning night time measurements, and consider

not allowing small children into the listening room at this time.

ENGLISH

1 2 ... 16 17 18 19 20 21 22 23 24 25 26 ... 81 82

No comments

Denon AVR-2105 Operations Instructions Page 21