Denon AVR-X5200W Owner's Manual Page 264

  • Download
  • Add to my manuals
  • Print
  • Page
    / 335
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 263
Symptom Cause / Solution Page
DTS Neo:X mode cannot
be selected.
0
It cannot be selected when “Speaker Config.” - “Surround” is set for “None”. 220
0
DTS Neo:X cannot be selected when using the headphones.
Dolby Surround mode
cannot be selected.
0
Dolby Surround cannot be selected when using the headphones.
Audyssey MultEQ
®
XT32,
Audyssey Dynamic EQ
®
,
Audyssey Dynamic
Volume
®
and Audyssey
LFC™ cannot be selected.
0
These cannot be selected when you have not performed Audyssey
®
Setup.
194
0
Switch to a sound mode other than “Direct” or “Pure Direct”. 130
0
These cannot be selected when using the headphones.
Audyssey DSX
®
cannot be
selected.
0
It can be selected when using the front height or front wide speakers. 221
0
It can be selected when using the center speaker. 220
0
Switch the sound mode to Dolby sound mode or DTS sound mode. 129
0
This cannot be selected when using the headphones.
0
This cannot be set when the input signal is a 2-channel source.
“Restorer” cannot be
selected.
0
Check that an analog signal or PCM signal (Sample Rate = 44.1/48 kHz) is input. For playback of
multichannel signals such as Dolby Digital or DTS surround, “Restorer” cannot be used.
169
0
Switch to a sound mode other than “Direct” or “Pure Direct”. 130
No audio is output from
PRE OUT or speakers for
ZONE2/ZONE3.
0
In ZONE2/ZONE3, the audio can be played back when signals input from digital connectors (OPTICAL/
COAXIAL) are in 2ch PCM format.
0
In ZONE2, the audio can be played back when signals input from the HDMI connector are in 2ch PCM
format. To play back the audio in ZONE2 irrespective of the input signal format, set “HDMI Audio” in the
menu to “PCM”. Depending on the played back device, the audio may not be played back even with this
setting. In that case, set the audio format to “PCM (2ch)” on the played back device.
240
0
When listening to audio from a Bluetooth device in ZONE2/ZONE3, remove any obstructions between the
Bluetooth device and this unit and use it within a range of about 10 m.
Contents Connections Playback Settings Tips Appendix
264
Front panel Display Rear panel Remote Index
Page view 263
1 2 ... 259 260 261 262 263 264 265 266 267 268 269 ... 334 335

Comments to this Manuals

No comments