Denon RCD-M33 User Manual download pdf (Page 9)

ENGLISH

• The supplied remote control unit (RC-999) is for use with the RCD-M33 unit only.

• If the cassette deck is connected to the main unit, you may operate each of the above components

using its respective remote control unit (refer to pages 9, 10).

REMOTE CONTROL UNIT

(1) Inserting the batteries

q Open the battery compartment cover of the

remote control unit.

Press the knob and open the cover in the

direction of the arrow.

w Insert the two R03 (AAA) batteries, following

the + and – marks in the battery compartment.

e Close the cover of the battery compartment.

Cautions on Batteries

• Use R03 (AAA) batteries in this remote

control unit.

• Replace the batteries with new ones after

approximately 1 year, though this depends

on the frequency with which the remote

control unit is used.

• Replace the batteries with new ones if the

unit does not operate when the remote

control unit is operated from nearby, even if

the batteries are less than a year old.

• Be sure to insert the batteries in the proper

direction, following the “ < ” and “ > ”

marks in the battery compartment.

• To avoid damage or leakage of battery fluid:

• Do not use a new battery with an old one.

• Do not use two different types of batteries.

• Do not short-circuit, take apart, heat or

dispose of batteries in flames.

• Remove the batteries when you do not plan

to use the remote control unit for an

extended period of time.

• If the battery fluid should leak, carefully wipe

off the fluid from the inside of the battery

compartment, then insert new batteries.

(2) Using the Remote Control Unit

• The remote sensor is located on the CD receiver.

Point the remote control unit at the remote

sensor as shown on the diagram when operating

it.

• The remote control unit will operate from a

direct distance of approximately 7 meters, but

this distance will be shortened if obstacles are

present or if operated at an angle. (The remote

control unit will operate at an angle of up to 30°

in either direction.)

30°

NOTES:

• The remote control unit may not operate if

the remote sensor is exposed to direct

sunlight or the strong light from a lighting

fixture, or if there is an obstacle between the

remote control unit and the remote sensor.

• Do not press buttons on the remote control

unit and on the set at the same time. Doing

so could result in malfunctions.

• If the remote control unit is pointed away

from the re-mote sensor during continuous

operations (such as when turning the volume

up or down), the operation will stop. If this

happens, point the remote control unit at the

remote sensor and press the button again.

The RCD-M33 comes with a system remote control unit (

RC-999

(3) Remote Control Unit Part Names and Functions

q SLEEP button

• Press this button to set the sleep timer.

w OFF button

•Use this switch to set the power to

STANDBY mode.

e TUNER button

• Press this button to set the function

TUNER mode.

r CD button

• Press this button to set the function CD

mode.

t PROG/DIRECT button

• Press this button to switch between

PROGRAM and DIRECT play.

y EDIT button

In CD function :

• Press this button for edited recording on a

tape, dividing the tracks onto sides A and

B according to the length of the tape.

In TUNER function :

• Press this button to input the station

name.

u CALL button

• Use this button to confirm the

programmed song.

i Number buttons

In CD function :

• Press these buttons to specify the

desired track.

In TUNER function :

• Press these buttons to recall preset

station.

o FOLDER (+ / –) button

For MP3/WMA discs with the function set

to CD:

• Select the folder.

• In the play and pause modes, the first

track in the selected folder is selected.

1.RCD-M33-E3-ENG 05.4.13 5:46 PM ページ 9

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 73 74

Comments to this Manuals

No comments

Denon RCD-M33 User Manual Page 9

Comments to this Manuals

Related products and manuals for CD players Denon RCD-M33