Denon AVR-1311 Owner's Manual Page 22

  • Download
  • Add to my manuals
  • Print
  • Page
    / 64
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 21
16
ENGLISH
Connecting an antenna
Connect the FM antenna or AM loop antenna supplied with the unit to enjoy listening to radio broadcasts.
• After connecting the antenna and receiving a broadcast signal (vpage20 “Listening to FM/AM broadcasts”), fi x the antenna with tape
in a position where the noise level becomes minimal.
weq
FM outdoor
antenna
75 Ω Coaxial
cable
Ground
AM outdoor
antenna
AM loop antenna
(supplied)
Black White
FM indoor
antenna
(supplied)
Direction of broadcasting station
n AM loop antenna assembly
1
Put the stand section
through the bottom of the
loop antenna from the
rear and bend it forward.
Stand
Square
hole
Projecting
part
Loop
antenna
2
Insert the projecting part
into the square hole in
the stand.
n Using the AM loop antenna
Suspending on a wall
Suspend directly on a wall without
assembling.
Nail, tack, etc.
Standing alone
Use the procedure shown left to
assemble.
NOTE
Do not connect two FM antennas simultaneously.
Even if an external AM antenna is used, do not disconnect the
AM loop antenna.
Make sure the AM loop antenna lead terminals do not touch
metal parts of the panel.
If the signal has noise interference, connect the ground
terminal (GND) to reduce noise.
If you are unable to receive a good broadcast signal, we
recommend installing an outdoor antenna. For details, inquire
at the retail store where you purchased the unit.
Connecting a control dock for iPod
Connect a control dock for iPod to the unit to enjoy video and music stored
on an iPod.
For a control dock for iPod, use ASD-11R, ASD-3N, ASD-3W, ASD-51N and
ASD-51W made by DENON (sold separately).
For instructions on the control dock for iPod settings, refer to the control
dock for iPod’s operating instructions.
R
L
R
L
ASD-51N
Control dock for iPod
zUse the AV/Control Cable supplied with the DENON
control dock for iPod.
z
Set this to change the digital input connector to which the input source
is assigned.
“Input Assign” (vpage33)
in Set as Necessary
1.AVR1311E2_ENG_3rd_100617.indd Sec:161.AVR1311E2_ENG_3rd_100617.indd Sec:16 2010/06/17 18:24:132010/06/17 18:24:13
Page view 21
1 2 ... 17 18 19 20 21 22 23 24 25 26 27 ... 63 64

Comments to this Manuals

No comments