Denon AVR 988 - AV Receiver Owner's Manual download pdf (Page 49)

Searching Categories

Press o p.

Use o p to select the category, then use ui to select

the desired station.

Channel category

Checking the XM Signal Strength and

Radio ID

Either turn <SOURCE SELECT> or press [SAT TU] to

select “XM”.

Press <STATUS> until “SIGNAL” appears on the

display.

The display will switch as shown below, depending on the

reception conditions.

Display Status

GOOD Signal strength is good

MARGINAL Signal strength is marginal

WEAK Signal strength is weak

NO No signal

Adjust the position of the antenna until “SIGNAL:

GOOD” is shown on the display.

Press <STATUS> until the station you want to check

(example: “XM001”) is displayed.

Press [TUNING] and select channel 0 (XM000).

The radio ID is shown on the display.

The strength of both the XM satellite and terrestrial signals can be

checked at menu “Input Setup” – “Antenna Aiming” (vpage 36).

Radio ID



Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting

1.AVR988EU_101_4th.indd 49 2007/09/13 11:32:38

1 2 ... 44 45 46 47 48 49 50 51 52 53 54 ... 79 80

No comments

Denon AVR 988 - AV Receiver Owner's Manual Page 49