Denon D RCD-M37 Owner's Manual download pdf (Page 13)



Getting Started Setup Playback Setting the Timer Other Functions Troubleshooting

ENGLISH

Speciﬁcations

Check the left (L) and right (R) channels and the + (red) and – (black)

terminals on the set and the speakers to be used and interconnect

the cables to the same polarities.

(R) (L)

w q w q

Connecting the Speaker Cables

Peel off about 10 mm of the sheathing at

the tip of the cable, twist the core wire and

terminate it.

Turn the speaker terminal counterclockwise

to loosen it.

Insert the speaker cable’s core wire into the

base of the speaker terminal.

Turn the speaker terminal counterclockwise

to tighten it.

NOTE

• Use speakers with an impedance of 6 to 16 Ω/ohms. The protection

circuit may be activated if speakers with an impedance other than

speciﬁed are used.

• Connect the speaker cables in a way that they do not stick out of the

speaker terminals. The protection circuit may be activated if the core

wires touch the rear panel or screws or if the + and – sides touch.

• Never touch the speaker terminals while the power is on. Doing so

could cause electric shock.

Protector circuit

The protection circuit will be activated in the following cases:

• When the speaker cable's core wires are touching the rear

panel or screws or when the speaker cable’s + and – sides are

touching

• When the surrounding temperature is extremely high

• When the internal temperature rises due to extended use with a

high output

If this happens, unplug the power cord, then check the connections

of the speaker cables and input cables. If the set’s temperature

is extremely high, wait for it to cool off and improve surrounding

ventilation. After doing this, plug the power cord back in.

If the protection circuit is activated though there are no problems

in ventilation around the set or in connections, the set could be

damaged. Turn off the power, then contact a DENON servicing and

inquiry outlet.

Speaker SC-M37 (Supplied)

Subwoofer

with built-in

ampliﬁer

Connections

Speaker Connections

When using a banana plug

Tighten the speaker terminal ﬁrmly before inserting the banana

plug.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 38 39

Comments to this Manuals

No comments

Denon D RCD-M37 Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Receiver Denon D RCD-M37