Denon AVR-1507 User Manual download pdf (Page 46)

ENGLISH

Advanced Setup – Part 2 Advanced Setup – Part 2

Setting the Subwoofer Mode Setup

Select the method of playback of the subwoofer for playing the low

bass signals.

LFE (Normal):

For any channel(s) that are set to “Large”, low frequencies in that

channel’s corresponding source are directed to that loudspeaker

only. The low frequencies played from the subwoofer are only the

LFE signals and the low frequencies of channels set to “Small”.

LFE+Main:

Low frequencies from speaker channels that have been set to

“Large” are reproduced from those speakers as well as from the

subwoofer(s).

• The subwoofer mode setting is only valid when and “Yes” is set for

the subwoofer in the “Setting the Speaker Configuration”.

• Select the “LFE+Main” mode if you want low frequency signals to

always be played from the subwoofer channel.

• Select the mode achieving a voluminous bass sound when playing

music or movie sources.

Press ENTER or

to enter the setting and switch to

the Distance setting.

Setting the Distance

This parameter is for optimizing the timing with which the audio

signals are produced from the speakers and subwoofer according to

the listening position.

Preparations:

Measure the distances between the listening position and the

speakers (L1 to L8 on the diagram at the below).

C FRFL

Listening position

SL SR

SBL

SBR

Press ENTER or

to enter the setting and switch to

the Crossover Frequency setting.

1 5 S W 3 . 6 m

Press

FF GG

to set.

7 S W M o d e +Main

8 F L 3 . 6 m

Press

FF GG

to set.

1 6 C r . O v e r 8 0 H z

8 F L 4 . 5 m

• The distance changes in units of 0.1 meters each time the button is

pressed. Select the value closest to the measured distance.

• Please note that the difference of distance for every speaker

should be 6.0 m or less.

Setting the Crossover Frequency

Set the frequency (Hz) below which the bass sound of the various

speakers is to be output from the subwoofer.

For speakers that are set to “Small”, frequencies under the crossover

frequency are cut before the signal is output, and the low frequency

component that was cut is output from the subwoofer or the

speakers that are set to “Large”.

40, 60, 80, 90, 100, 110, 120, 150, 200, 250 Hz:

Set as desired according to your speakers’ bass playback ability.

Press ENTER or

to enter the setting and switch to

the Test Tone setting.

•The crossover frequency mode is valid only when subwoofer is set

to “ON”, and when one or more speakers are set to “Small”, as

described in section “Setting the Speaker Configuration” ( page

41).

• Set to “80 Hz” when using regular speakers. When using small

speakers, we recommend setting to a higher frequency.

Press

FF GG

to set.

1 6 C r . O v e r 1 0 0 H z

1 7 T . T o n e Y e s <

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 63 64

Comments to this Manuals

No comments

Denon AVR-1507 User Manual Page 46

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-1507