Denon AVR-1907 User Manual download pdf (Page 45)

Advanced Operation Advanced Operation

ENGLISH

¢ Last function memory

The various settings set when the AVR-1907’s power is switched to

standby are stored in the memory. When the power is turned back on,

the settings made when the power was switched to standby are

recalled.

About the memory functions

¢ Backup memory

The various settings are stored in the memory for about 1 week, even

when the power is turned off or the power cord is unplugged.

Initialization of the microprocessor (Reset)

Use the procedure described below to reset the microprocessor if the

display is abnormal or if the buttons on the main unit or the remote

control unit do not operate.

Switch off the unit using

POWER

Check that the entire display is blinking with an interval

of about 1 second, and release your fingers from the 2

buttons.

• The microprocessor will be initialized.

Hold the following

SPEAKER

(A and B) and press

POWER

• If step 3 does not work, start over from step 1.

• If the microprocessor has been reset, all the settings are reset to the

default values.

Recording (audio and/or video)

Press

ZONE2/REC SELECT

until “RECOUT” appears

on the display.

Use

FUNCTION

to select the source to be recorded

(audio and/or video).

• The “ ” indicator and the indicator for the selected

source light.

Record (the audio or video signals).

For operations, see the operating instructions of the device from

which you are recording (audio or video signals).

•To cancel, press

ZONE2/REC SELECT

and set the function to “ZONE2”.

NOTE:

• When the REC OUT mode is selected, [ZONE2] and [FUNCTION]

(ZONE2) cannot be operated.

• Digital signals are not output from the analog REC OUT terminal.

RECOUT

ZONE2

1 2 ... 40 41 42 43 44 45 46 47 48 49 50 ... 73 74

Comments to this Manuals

No comments

Denon AVR-1907 User Manual Page 45

Comments to this Manuals

Related products and manuals for Receivers and Amplifiers Denon AVR-1907