Denon DHT-S514 Specifications download pdf (Page 4)

Locating DHT-S514 Components

The sound bar of the DHT-S514 should be place as close as possible to the television screen. It should

be centered left-to-right with the screen, and ideally no more than a few inches above or below. The

most common location is below the screen. Sometimes this location can be diﬃcult, because the base

of the TV gets in the way. The DHT-S514 has two sets of feet – 19 mm and 31 mm high – that raise

the sound bar oﬀ the shelf, for a more stable and attractive installation when used with this type of

television.

Note: Depending on your TV model or installation location, the remote control receiver on the TV

may be hidden by the sound bar, preventing the remote control from being used because the remote

control signals cannot reach the TV. In this case, connect the supplied IR Blaster. Attach the tip of the IR

Blaster near the TV remote control signal receiver and check that the remote control can be used to control the TV.

HDMI IN

HDMI OUT (ARC)

PAIR

ANALOG IN

OPTICAL

DIGITAL IN

COAXIAL

DIGITAL IN

DC IN

SERVICE

IR BLASTER OUT

TO TELEVISION

COAXIAL DIGITAL IN

OPTICAL DIGITAL IN

HDMI IN

HDMI OUT (ARC)

SERVICE

IR BLASTER OUT

TO TELEVISION

Remote control sensor of the TV

IR Blaster cable (supplied)

You may also place DHT-S514 sound bar on a shelf, or furniture, above or below the screen. It should be centered with the screen, and ideally no

more than a few inches above or below. The system will usually sound best when the front of the sound bar is close to, or ﬂush with, the front

edge of the furniture or shelf on which it rests. This reduces unwanted sound reﬂections.

Place the wireless subwoofer anywhere in the room. For the best sound, place the subwoofer

near a wall or corner, within 6 meters of the sound bar, and on the same side of the room

as the sound bar. The wireless subwoofer range is 8 meters. Wireless subwoofer can be

positioned vertically or horizontally. Attach the supplied non-slip stickers to the subwoofer.

Note: Don’t put the subwoofer where curtains or furniture will block the sound. The port on

the back of the subwoofer cabinet should be unobstructed.

Wall-Mounting

The DHT-S514 sound bar can be wall-mounted using the integrated keyhole mounts. A mounting template can be found in the product carton.

Using a level, position and tape the template to the wall in the desired location. Install hardware* using the template as a guide and then

remove the mounting template from the wall. Connect the audio and power cables prior to mounting the sound bar on the wall.

*Consult a person knowledgeable about your wall type to recommend suitable hardware for hanging the speaker.

Wall Mounting Keyholes

Note: To ensure safety, request a contractor perform the mounting work when mounting onto a wall.

In order to use the unit safely, do not place items on or hang items from the unit.

Be sure to ﬁx connection cables to the wall to ensure that cannot be pulled or tripped over causing the unit to fall. Check that the unit is

mounted safely after the mounting work is complete.

Also, periodically check the safety of the unit and whether there is a possibility that the unit may fall.

Denon cannot accept any responsibility for damage, injury or accidents caused by problems with the mounting location or mounting method.

Feet

1 2 3 4 5 6 7 8 9 ... 41 42

Comments to this Manuals

No comments

Denon DHT-S514 Specifications Page 4

Comments to this Manuals

Related products and manuals for Soundbar speakers Denon DHT-S514