Denon DN-U100 Operations Instructions download pdf (Page 9)

ENGLISH

ENGLISH ENGLISH

Getting Started

q Power operation switch (ON/STANDBY)

When pressed, the power turns on and the display lights.

The muting mode is set for several seconds, after which

the DN-U100 will function normally.

When pressed again, the power is set to the “standby”

mode and the display turns off.

w STEREO indicator

In the AUTO mode, this lights when a stereo broadcast is

tuned in. ( page 9)

e TUNED indicator

This lights when the strength of the reception frequency is

at or above a speciﬁc level. ( page 9)

r RDS indicator

This lights when receiving RDS broadcasts, and ﬂashes

during the RDS search. ( page 11 ~ 14)

t ON/STANDBY indicator

This lights when the DN-U100’s power is in the “on” or

“standby” mode.

y Remote control sensor

This is the remote control signal sensor.

u Display

i DIMMER button

The display’s brightness can be adjusted in three steps.

Press this button to switch the brightness between high,

medium and low, in that order.

o BAND button

Press this button to switch the band between FM and AM.

( page 9)

!0 AUTO PRESET button

When pressed while the FM band is set, the DN-U100

searches for stations that can be received in stereo and up

to 100 stations are automatically stored at the preset

channels. (The stations are stored in order starting from

channel A1.) ( page 8)

!1 MENU button

Press this button to set the MENU mode. ( page 10 ~

15)

!2 TUNING/PRESET knob

When in the tuning mode, use this knob to raise or lower

the frequency. Turn the knob clockwise to raise the

frequency, counterclockwise to lower the frequency. Use

the knob together with the MENU button to switch the

mode setting. ( page 10 ~ 16)

!3 FM antenna terminals

(ANTENNA TERMINAL FM)

75 Ω/ohms coaxial cables can be connected to these

terminals. For the connection procedure, see the section

“Connections”. ( page 6)

!4 AM antenna terminals

(ANTENNA TERMINAL AM)

Connect the included AM loop antenna. ( page 6)

Connect with this terminal when a medium wave outdoor

antenna is used.

!5 Analog output jacks

Connect these to the TUNER input terminals on the pre-

main ampliﬁer. ( page 7)

!6 AC Inlet

Connect the included power supply cord here. ( page

• Whenever the unit is in the STANDBY state, the unit is still

connected to AC line voltage.

Please be sure to unplug the power supply cord when you

leave home for, say, a vacation.

• Noise may be generated if a nearby television set is on

during the broadcasting reception. The tuner should be used

as far away from a television as possible.

• The unit is also equipped with a back-up memory. This

function provides memory storage when the power switch

is off and with the power supply cord disconnected.

Part names and functions

For details on the functions of these parts, refer to the pages given in parentheses ( ).

Front panel

Rear panel

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 23 24

Comments to this Manuals

No comments

Denon DN-U100 Operations Instructions Page 9

Comments to this Manuals

Related products and manuals for Car media receivers Denon DN-U100