Denon AVR 1909 - AV Receiver Owner's Manual download pdf (Page 31)

ENGLISH

The auto setup measurement results

are

stored

the AVR-1909.

Press 6. to

select"

Store ...... then press

<3.

• "Storing Please wait···

displayed on the on-screen display

while the results are being stored.

• When storing

complete, "Storing complete. Auto Setup

now

finished."

displayed

the on-screen display.

Select"

Exit". then press

ENTER.

® Disconnect the setup microphone from the AVR-1909.

Error Messages

If the auto setup procedure could not be completed due

speaker installation, the measuring environment. etc.,

error message is

displayed. If this happens, check the relevant items, be sure

take the necessary measures,then perform the auto setup procedure over

again.

Measures

accurate • Either turn off any device generating noise or move it

away.

•

Try

again

when the surroundings

are

quieter.

low for • Check the speaker installation

and

the direction

which the speakers

are

facing.

• Adjust the subwoofer's volume.

Cause

• Included setup microphone

not connected. • Connect the included setup microphone to the

SETUP

MIC

jack

the main unit.

• Check the speaker connections.

properly

•

Too

much noise

the room for

measurements to

made.

• Not

all

speakers could be detected.

• The front L speaker was not

detected.

• Speaker or subwoofer sound

too

accurate measurements to

made.

Error

messages

(examples)

)

[J"Store~

Cancel~

• Menu screen •

(

Step

5 :Store

oTo cancel storing

Press 6.

to select "Cancel ...... then press

<3.

• All the measured auto setup

data

will be erased.

_Ntn.

not turn the power off while the settings

are

being stored.

Ret

r y

Cancel~

Auto

Setup

AudweL

I t

t4.'~"'.

[J"~

Fro

n t

-i

,I4

Retry~

Cancel~

• Displayed speaker could not

detected. • Check the connections of the displayed speaker.

The

front R speaker were not properly

detected.

Only one channel of the surround speakers

was detected.

Sound was output from the R channel

when only one surround back speaker was

connected.

The

surround

back.

but the surround speaker

was not detected.

Auto

Setup

Aud

I t

~~=

!!i!!!!i!A·U

[J'

Fro

n t

Ret

r y

Cancel~

Ski

• Displayed speaker connected with

polarities reversed.

the • Check the polarities of the displayed speaker.

•

For

some speakers. this error message may be

displayed even if the speaker

properly connected. If

you

are

sure that the wiring

correct,

select"

Skip".

:ft.:.

Select"

Retry" to measure again.

-Ntii.

sure to turn the power off before checking the speaker connections.

1 2 ... 26 27 28 29 30 31 32 33 34 35 36 ... 102 103

Comments to this Manuals

No comments

Denon AVR 1909 - AV Receiver Owner's Manual Page 31

Comments to this Manuals

Related products and manuals for Receiver Denon AVR 1909 - AV Receiver