Denon AVR-688 User Manual download pdf (Page 24)



Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting

ENGLISH

s Error Messages

If the auto setup procedure could not be completed due to speaker installation, the measuring environment,

etc. an error message is displayed. Check the relevant items and be sure to take the necessary measures. After

addressing any issues, perform the auto setup procedure over again.

NOTE

Be sure to turn the power off before checking speaker connections.

Select “Retry” to make the measurements again.

Getting Started Connections Setup Playback Remote Control Multi-Zone Information Troubleshooting

Error messages (examples) Cause Measures

M i c o r S p : N O N E

• The included setup microphone is not

connected.

• Not all speakers could be detected.

• Connect the included setup

microphone to <SETUP MIC>.

• Check the speaker connections.

A m b i e n t N o i s e

• Too much noise in the room for

accurate measurements to be made.

• Speaker or subwoofer sound is too

low for accurate measurements to be

made.

• Either turn off any device generating

noise or move it away.

• Try again when the surroundings are

quiter.

• Check the speaker installation and the

direction in which the speakers are

facing.

• Adjust the subwoofer’s volume.

C a u t i o n : S p N o n e

F R

• Displayed speaker could not be

detected.

· The front L and front R speakers

were not properly detected.

· Only one channel of the surround

speakers was detected.

· Sound was output from the R

channel when only one surround

back speaker was connected.

· The surround back speaker was

detected, but the surrounds were

not detected.

• Check the connections of the

displayed speaker.

C a u t i o n : P h a s e

S B L

• Displayed speaker connected with

the polarities reversed.

• Check the polarities of the displayed

speaker.

• For some speakers, this error

message may be displayed even if

the speaker is properly connected. If

you are sure that the wiring is correct,

select “Skip”.

NOTE

Do not turn the power off while the settings are being stored.

Step 4 : Check

Once the calculation is completed, a measuring result check (“Parameter Check”) is displayed.

Press o to check the result.

Press ui to select the item, then press o.

Values that are different from the actual distance may be set for speakers with built-in ﬁ lters

(subwoofers, etc). This is because ﬁ lters add electrical delay to the signal that should be

compensated.

Step 5 : Store

The auto setup measurement results are stored in the AVR-688 or cancelled.

After checking, press ENTER to select “Store”, then press ui to select “Store” or “Cancel”.

Store :

Press o to store this calibration permanently to memory.

Cancel : Press o to cancel this calibration and clear all Auto Setup data measured.

Step 3 : Calculation

When “Calculate” is selected at “Step 2”, the measurements taken are analyzed automatically

to determine how the speaker system interacts with the room.

“Calculate” is displayed when you have completed measurements in 6 positions. To complete

Step 2 in 5 or less positions, press i to select “Calculate”.

The time required for this analysis depends on the number of speakers connected. The higher

the number of speakers, the longer the time required for analysis.

NOTE

Do not change the speaker connections or subwoofer volume, or speaker locations after making

measurements. These types of changes will invalidate the EQ solution provided. If changes

are necessary, make the changes and use the Audyssey MultEQ Auto Setup once again for an

updated EQ solution.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 67 68

Comments to this Manuals

No comments

Denon AVR-688 User Manual Page 24

Comments to this Manuals

Related products and manuals for Receiver Denon AVR-688