Denon RC-7000CI - Remote Control - Infrared/radio Owner's Manual Page 12

  • Download
  • Add to my manuals
  • Print
  • Page
    / 38
  • Table of contents
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 11
ENGLISH
Using
the
Macro function
This function allows you to register a series
of
operations at a single button.
With this function you can for example turn on the
amplifier, select the input source, turn on the
TV's
poWer,
turn on the source device's (equipment) power
and
set the play mode
aU
by pressing a single button.
* Press
DEVICE
to select the device.
* Repeat steps 5 to
6.
7Press
NEXT
to register the next signal.
3Press
[ADDIREDO].
2 Press
[MACROS].
6Press the button at which
you
want to
register the macro.
* Macros
can
be
registered at buttons other than
NEXT,
BACK
and
DEVICE.
5
At the "Assign Macro" screen, press the
LCD
button
for the device (equipment) for
which you want to register the macro.
4 Press
NEXT
twice.
1
Press
RC
SETUP
for 3 seconds.
The
"PROGRAM DEVICE" menu
is
displayed.
"Success!"
is
displayed if the
code was learned successfully.
* Press
[EDIn
if you want to change the button name.
Perform the procedure at "Changing the button name"
(@'"
page
18)
starting from step
7.
7Place the remote control units with their
signal transmitters facing each other, press
NEXT,
then immediately press the button
on the remote control unit you want to
register.
9Press
[EXITI
to exit the learning mode.
8
To
register other buttons, press
NEXT.
* Repeat steps 6 to
8.
&IiIt
The
learning function may not work for some remote control
units,
and
sometimes a device may not operate properly even
if its remote control signals
have
been learned.
In
this
case,
use the remote control unit included with the device.
LCD
button
RC
SETUP
5iI
LCD
button
About the button names
in
these explanations
[ 1 :
LCD
buttons for selection items
Button
name
only:
Indicates a button
on
the remote control unit
8
Page view 11
1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 37 38

Comments to this Manuals

No comments