Denon AVP-A1HD Owner's Manual Page 20

  • Download
  • Add to my manuals
  • Print
  • Page
    / 87
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 19

Getting Started Connections Other Operations Multi-Zone Information Troubleshooting SpecificationsPlaybackSetup
RETURN
ENTER
uio
STEP5 Check
In STEP 5, the results of the analysis from STEP 4 are confirmed.
1
Use ui to select the item you want to check, and
then press ENTER.
AUTO SETUP
1 2 3 4 5 6
Crossover Check
Ch. Level Check
Distance Check
Spkr Config Chck
RETURN
Next→Store
STEP5 Check
Check processing results.
To proceed, press "Next".
Proceed to STEP 6 (Store)
Enter Cancel
b
A value that is different to the measured distance may be set.
b To check other items, press
RETURN
and select the item that you
want to check.
2
Use i to select “Next Store” and then press
ENTER.
Proceed to “STEP6 Store” (vpage 19).
NOTE
If the result differs from the actual connection status, or if “Caution!”
is displayed, see “Error messages” (vpage 21). Check the related
items, and implement the necessary measures. After resolving the
error, perform Auto Setup again.
If the result still differs from the actual connection status after
remeasurement or the error message still appears, it is possible that
the speakers are not connected properly. Turn this unit off, check the
speaker connections and repeat the measurement process from the
beginning.
If you change speaker positions or orientation, perform Auto Setup
again to find the optimal equalizer settings.
STEP6 Store
In STEP 6, the measured results from STEP 2 and STEP 3 are saved.
Select “Store” and then press ENTER.
Save the measurement results.
AUTO SETUP
1 2 3 4 5 6
RETURN
Store
STEP6 Store
Press "Store" to store calculation results.
Apply and store measurement result
Enter Cancel
AUTO SETUP
1 2 3 4 5 6
STEP6 Store
Now storing…Please wait.
20%
b
It takes approximately 20 seconds to finish saving the results.
b If the measuring results are not to be saved, press RETURN. A
message “Cancel auto setup?” will be displayed. Press o then
select “Yes”. All the measured Auto Setup data will be erased.
NOTE
During saving of measurement results, be sure not to turn off the
power.
uio
RETURN
ENTER
(Main remote control unit) (Sub remote control unit)
ENTER
RETURN
uio
Page view 19
1 2 ... 15 16 17 18 19 20 21 22 23 24 25 ... 86 87

Comments to this Manuals

No comments