Denon POA-A1HDCI Owner's Manual download pdf (Page 13)

Bi-Amp Connections

When using speakers that have input terminals for both woofer units and tweeter units, this

connection outputs one input signal from the two amps on the main unit to each of these units.

With this connection the interference between signals for the woofer unit and tweeter unit is

eliminated so that you can enjoy high quality sound in playback.

• Bi-Amp output is setup using the following combination of channels. The input terminals to be used are

as follows.

and input terminal :

channels

and input terminal :

channels

and

input terminal :

channels

and

input terminal :

channels

and

input terminal :

channels

• Set each switch as shown below.

q Set the Operation mode select switch to “Bi-AMP” (vpage 6).

w Set the Input select switch according to the input (vpage 6).

· For RCA input ·········· Set to “RCA”.

· For XLR input ·········· Set to “XLR”.

SPEAKERS

XLR

RCA

SPEAKERS

XLR

RCA

SPEAKERS

XLR

RCA

SPEAKERS

XLR

RCA

SPEAKERS

XLR

RCA

HIGH

LOW

w q

"6%*0

065

13&13&

065

Example: Bi-Amp connection using and channels

b Setup each pair channel using the same steps.

NOTE

• The same signal is output to channel

and channel

• No signal is output from the speaker B terminal.

• Use speakers with an impedance of 4 ~ 16 Ω/ohms.

NOTE

The input terminal (channel in case of and ) that is not used for this setting becomes invalid

regardless of the status of Input select switch.

Input select switchOperation mode select switch

0

Getting Started Connections and Settings Operations Troubleshooting

1.POA-A1HDCIEU.indd 13 2008/01/18 11:07:19

1 2 ... 8 9 10 11 12 13 14 15 16 17 18

Comments to this Manuals

No comments

Denon POA-A1HDCI Owner's Manual Page 13

Comments to this Manuals

Related products and manuals for Audio amplifiers Denon POA-A1HDCI