Denon POA-A1HDCI Owner's Manual download pdf (Page 9)

Settings

NOTE

The MODE, CONTROL, Operation mode select switch and Input select

switch must be set before turning the power on. Settings which are

changed after powering on will not be registered. In such cases, the

power should be switched off and on again.

SPEAKERSSPEAKERSSPEAKERSSPEAKERSSPEAKERS

CONTROL

Input select

switch

Operation mode

select switch

MODE

[Rear panel]

Change the input mode

Change the input mode for each channel (L1 ~ L5, R1 ~ R5).

Set the Input select switch.

•

XLR

: Use XLR terminal.

•

RCA

: Use RCA terminal.

•

OFF

: Channel is not used.

NOTE

• When the input and Input select switch setting on the unit are

different, the unit does not operate.

• If CONTROL is set to “AVP”, this setting is invalid.

Change the operation mode

Change the operation mode for each channel (L1 ~ L5, R1 ~ R5)

or pair channel (L1 / L2, L3 / L4, L5 / R5, R1 / R2, R3 / R4).

Bi-AMP / NORMAL / BRIDGE mode selection

Set how to use the power amp with each channel.

Set the Operation mode select switch.

•

Bi-AMP

: Used for Bi-Amp connection.

•

NORMAL

: Used for NORMAL connection.

•

BRIDGE

: Used for BRIDGE connection.

OPTION / 1 / 2 mode selection

Use control link to connect POA-A1HDCI and AVP-A1HDCI and switch

POA-A1HDCI according to the number of units to be connected.

Select MODE.

•

OPTION

: For future use, if the range of functions is expanded.

•

: Used as the ﬁ rst unit when one POA-A1HDCI unit is

used or two POA-A1HDCI units are connected.

•

: Used as the second unit when two POA-A1HDCI units

are connected.

NOTE

• Channels that have the input mode set to “OFF” can not be

selected.

• If CONTROL is set to “AVP”, this setting is invalid.

Select CONTROL.

•

AVP

: Operates the unit from the AVP-A1HDCI (vpage

7).

•

OFF

: Control mode is not used.

•

EXTERNAL

: Operates the unit from equipment connected

to the RS-232C connector or TRIGGER IN jack

(vpage 12).

Change the control mode

Select the option suited for the equipment operating the unit.

When

CONTROL

is set to “ AVP”, the PRE AMP CONTROL LINK indi-

cator lights in blue.

Getting Started Connections and Settings Operations Troubleshooting

1.POA-A1HDCIEU.indd 9 2008/01/18 11:07:01

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 17 18

Comments to this Manuals

No comments

Denon POA-A1HDCI Owner's Manual Page 9

Comments to this Manuals

Related products and manuals for Audio amplifiers Denon POA-A1HDCI