Denon AVR-1906 User Manual download pdf (Page 12)

ENGLISH

Easy Setup and Operation Easy Setup and Operation

ENGLISH

Starting Auto Setup

Press the CURSOR

button to select “Auto

Setup”, then press the ENTER button.

• The “Auto Setup” screen appears.

Press the SETUP button.

• The “System Setup” menu appears.

Measurement of each channel is performed as follows:

Press the CURSOR

button to select

“Start”, then press the CURSOR

button.

•Start the measurements.

FL FR C SW SL SR

SBL SBR

1 2 3

1: Only the front speakers (A) are measured, front speakers

(B) are not available. Even if the front speakers (B) are

set, the setting automatically switches to the front

speakers (A) once measurements are completed.

2: The subwoofer speaker is measured twice.

3: When “ZONE2” and “Bi-Amp” are selected, these are

not displayed.

After each channel is measured, “Calculating” appears.

The display switches to the Auto Setup check screen

automatically.

•Measurement is cancelled if the MASTER VOLUME control knob

is operated while the Auto Setup is performed.

• If the output volume and crossover frequency of your

subwoofer speaker can be changed, then set the volume to

halfway and the crossover filter to maximum or switch off

the low-pass filter.

2 About automatic retry

To confirm the results of the measurements, remeasurement is

automatically performed.

Remeasurement is performed up to 2 times. During this time,

“Retry1” or “Retry2” is displayed on the screen.

NOTE:

•When measurements have been made using the

measurement microphone, speakers with built-in filters,

such as a subwoofer, might be set to a value that differs

from the physical distance because of the internal electrical

delay.

When “S. Back” is selected, the test tone during Auto

Setup will be output from the surround back speaker.

When “ZONE2” is selected, change the setting to

“ZONE2”. The test tone during Auto Setup is set so that it

will not be output to ZONE2 (Another room).

When “Bi-Amp” is selected, change the setting to “Bi-

Amp”. The test tone during Auto Setup is set so that it will

be output from the Bi-Amp speaker.

Press the CURSOR

button to select

“Power Amp Assign”, then press the CURSOR

button to select “S. Back”, “ZONE2” or

“Bi-Amp”.

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 66 67

Comments to this Manuals

No comments

Denon AVR-1906 User Manual Page 12

Comments to this Manuals

Related products and manuals for AV receivers Denon AVR-1906