Denon AVR-S500BT Owner's Manual download pdf (Page 84)

Levels

Set the volume of the test tone to be the same at the listening position

when it is output from each speaker.

Test Tone Start

A test tone is output from the selected speaker.

While listening to the test tone, adjust the volume output from the

selected speaker.

–12.0 dB – +12.0 dB (Default : 0.0 dB)

The set “Levels” are reflected in all sound modes.

When headphones are connected to the PHONES connector on this unit, you

cannot set “Levels”.

Set Defaults

The “Levels” settings are returned to the default settings.

Crossovers

Set in accordance with the lower limit frequency of the base frequencies

that can be played back through each speaker.

Set the crossover frequency

40 Hz / 60 Hz / 80 Hz / 90 Hz / 100 Hz / 110 Hz /

120 Hz / 150 Hz / 200 Hz / 250 Hz

(Default : 80 Hz)

“Crossovers” can be set when the “Subwoofer Mode” setting is “LFE+Main”, or

when you have a speaker that is set to “Small”. (v

p. 85)

The default crossover frequency is “80 Hz”, which will work best with the

widest variety of speakers. We recommend setting to a higher frequency that

the crossover frequency when small speakers are used. For example, set to

“250 Hz” when the frequency range of the speakers is 250 Hz – 20 kHz.

Sounds below crossover frequency is cut off in the output from the speaker set

up in “Small”. The cut off bass frequencies is output from the sub-woofer or

front speaker.

Contents Connections Playback Settings Tips Appendix

Front panel Display Rear panel Remote Index

1 2 ... 79 80 81 82 83 84 85 86 87 88 89 ... 139 140

No comments

Denon AVR-S500BT Owner's Manual Page 84