Denon AVR-S500BT Owner's Manual Page 96

  • Download
  • Add to my manuals
  • Print
  • Page
    / 140
  • Table of contents
  • TROUBLESHOOTING
  • BOOKMARKS
  • Rated. / 5. Based on customer reviews
Page view 95
o
Desired sound does not come out
Symptom Cause / Solution Page
The volume does not
increase.
0
The maximum volume is set too low. Set the maximum volume using “Limit” on the menu. 71
0
Appropriate volume correction processing is performed according to the input audio format and settings,
so the volume may not reach the upper limit.
No sound comes out with
the HDMI connection.
0
Check the connection of the HDMI connectors. 26
0
When outputting HDMI audio from the speakers, set “HDMI Audio Out” on the menu to “AVR”. To output
from the TV, set “TV”.
73
No sound comes out of a
specific speaker.
0
Check that speaker cables are properly connected. 22
0
Check that a selection other than “None” is set for the “Speaker Config.” setting in menu. 82
0
When the sound mode is “Stereo” and “Virtual”, audio is only output from the front speakers and
subwoofer.
No sound is produced from
subwoofer.
0
Check the subwoofer connections. 23
0
Turn on the subwoofer’s power.
0
When “Speaker Config.” - “Front” in the menu is set to “Large”, depending on the input signal and the
sound mode, no sound may be output from the subwoofer.
82
0
When no subwoofer audio signal (LFE) is included in the input signals, no sound may be output from the
subwoofer.
85
0
You can make the subwoofer always output sound by setting the “Subwoofer Mode” to “LFE+Main”. 85
DTS sound is not output.
0
Check that the digital audio output setting on the connected device is set to “DTS”.
0
Set “Decode Mode” on the menu to “Auto” or “DTS”. 76
Dolby TrueHD, DTS-HD,
Dolby Digital Plus audio is
not output.
0
Make HDMI connections. 30
0
Check the digital audio output setting on the connected device. On some devices, “PCM” is set by
default.
Dolby PLg mode or DTS
Neo:6 mode cannot be
selected.
0
It cannot be selected when “None” is set for “Speaker Config.” - “Center” and “Surround”. 83
0
Dolby PLg or DTS Neo:6 cannot be selected when using headphones.
Contents Connections Playback Settings Tips Appendix
96
Front panel Display Rear panel Remote Index
Page view 95
1 2 ... 91 92 93 94 95 96 97 98 99 100 101 ... 139 140

Comments to this Manuals

No comments