Denon AVR-X3000 Owner's Manual download pdf (Page 24)

Appendix

TipsSettingsPlayback

Contents

Front panel Display Rear panel IndexRemote

Connections

Speaker connection

Here we connect the speakers in the room to this unit.

This section explains how to connect them using typical examples.

NOTE

•Disconnect this unit’s power plug from the power outlet before connecting the

speakers. Also, turn o the subwoofer.

•Connect so that the speaker cable core wires do not protrude from the speaker

terminal. The protection circuit may be activated if the core wires touch the rear

panel or if the + and – sides touch each other (vpage215 “Protection circuit”).

•Never touch the speaker terminals while the power cord is connected. Doing so

could result in electric shock. When the “Setup Assistant” is running, follow the

instructions in the “Setup Assistant” screen for making connections. (Power is not

supplied to the speaker terminals while the “Setup Assistant” is running.)

•Use speakers with an impedance of 6 – 16 Ω/ohms.

2 Connecting the speaker cables

Carefully check the left (L) and right (R) channels and + (red) and –

(black) polarities on the speakers being connected to this unit, and be

sure to connect the channels and polarities correctly.

Peel o about 10 mm of sheathing from

the tip of the speaker cable, then either

twist the core wire tightly or terminate it.

Turn the speaker terminal counterclockwise

to loosen it.

Insert the speaker cable’s core wire to the

hilt into the speaker terminal.

Turn the speaker terminal clockwise to

tighten it.

1 2 ... 19 20 21 22 23 24 25 26 27 28 29 ... 231 232

No comments

Denon AVR-X3000 Owner's Manual Page 24