Denon AVR 4806 - AV Receiver Operations Instructions download pdf (Page 77)

Advanced Operation

System call

• The accessorius remote control unit is equipped with

“system call” function allowing a series of remote control

signals to be transmitted by pressing a single button.

This function can be used for example to turn on the

amplifier’s power, select the input source, turn on the

monitor TV’s power, turn on the source component’s power

and set the source to the play mode, all at the touch of a

single button.

2 System call buttons

• Up to 12 signals each can be stored at the SYSTEM CALL 1

~ 6 buttons.

• The System Call function can be used in the AMP, ZONE2,

ZONE3 and ZONE4 modes.

2 Storing system call signals

Press the ON and OFF button at the same time.

Press the 3 button to select system call setting.

Press the MODE SELECTOR button for the

component you want to register at the

SYSTEM CALL button, then press the ENTER

button.

Press the button you want to register.

The mode can be switched by pressing a MODE

SELECTOR button.

Repeat steps 4 to register the desired buttons.

Up to 12 signals each can be stored at the SYSTEM

CALL 1 ~ 6.

Press the ENTER button after the button

registration is completed.

• There will be a changeover to the system call

registration screen.

Press buttons from SYSTEM CALL 1 to 6 to

• “OK” is displayed and the set returns to the normal

operating mode.

2 Using the system call function

NOTE:

• The remote control signals of the buttons pressed while

registering the system call signals are emitted, so be

careful not to operate the components accidentally (cover

the remote sensors, for example).

Press the button at which the system call signals

have been stored.

• The stored signals are transmitted successively.

Punch Through

• Buttons used in the CD, CDR, DVD, DVDR, VDP, VCR1 and

VCR2 modes can be assigned to the buttons which are not

normally used in the AMP, ZONE2, ZONE3, ZONE4, TV and

DBS modes.

For example, when the CD mode is set to the punch

through mode in the AMP mode, the CD mode’s PLAY,

STOP, MANUAL SEARCH, AUTO SEARCH and PAUSE

buttons’ signals are sent in the AMP mode. — ( )

Press the ON and OFF button at the same time.

Press the 4 button to select punch through

setting.

Press the MODE SELECTOR button for the

component you want to make the punch

through setting, then press the

ENTER button.

Press the MODE SELECTOR button for the

component you want to punch through, then

press the

ENTER button.

• The punch through is set and the set returns to the

normal operating mode.

• If you exceed the number of signals that can be registered,

there will be a changeover to the system call registration

screen.

1 2 ... 72 73 74 75 76 77 78 79 80 81 82 ... 153 154

Comments to this Manuals

No comments

Denon AVR 4806 - AV Receiver Operations Instructions Page 77

Comments to this Manuals

Related products and manuals for Receiver Denon AVR 4806 - AV Receiver